Re: New CD/DVD drive - 80-wire cable detection failure

[Nick Warne]

On Friday 19 October 2007 22:44:27 Bartlomiej Zolnierkiewicz wrote:
>
> Ah, so the patch won't help (sorry, I didn't pay enough attention).
>
> Len's advices are worth the try, also please send the output
> of hdparm -I /dev/hdd.
>
> Thanks,
> Bart

Yes, Len's advice has me wondering now.  Do I have a dodgy cable? I will have 
to change that tomorrow.

But more info.  The old drive played DVD movies etc. OK, but slowly it became 
worse until I couldn't read any one of them 9 times out of 10.  CD play 
back/burning was OK 100% all the time though - so I guessed the dvd laser 
(whatever it does) was dead - hence why I bought a new one. 

The new drive works perfectly, but for the udma33 issue.  If it was the cable, 
why would it read/burn CD OK, but not DVD sometimes on the old drive?

hdparm -I

/dev/hdd:

ATAPI CD-ROM, with removable media
        Model Number:       TSSTcorp CDDVDW SH-S202J
        Serial Number:
        Firmware Revision:  SB00
Standards:
        Supported: CD-ROM ATAPI-3 -4 -5 -6 -7
Configuration:
        DRQ response: 50us.
        Packet size: 12 bytes
Capabilities:
        LBA, IORDY(cannot be disabled)
        DMA: mdma0 mdma1 mdma2 udma0 udma1 *udma2 udma3 udma4
             Cycle time: min=120ns recommended=120ns
        PIO: pio0 pio1 pio2 pio3 pio4
             Cycle time: no flow control=383ns  IORDY flow control=120ns

BTW, thanks for help all.

Nick
-- 
Free Software Foundation Associate Member 5508
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/