Re: [PATCH] x86: provide a DMI based port 0x80 I/O delay override.

[Rene Herman]

On 01-01-08 23:39, H. Peter Anvin wrote:

> > > Yes, we do.  It's exactly this side effect which makes this safer 
> > > than either 0x80 or 0xED -- it's a port that *guaranteed* can't be 
> > > reclaimed for other purposes without breaking MS-DOS compatibility.
> >
> > I see that with CR0.NE set (*) we indeed don't care about IGNNE#...
> >
> > However, I'm worried about this comment in arch/x86/kernel/i8259_32.c
> >
> > ===
> > /*
> >  * New motherboards sometimes make IRQ 13 be a PCI interrupt,
> >  * so allow interrupt sharing.
> >  */
> > ===
> >
> > Is it really safe to just blindly negate IRQ13 on everything out 
> > there, from regular PC through funky embedded thingies?
>
> It's not any IRQ 13, it's IRQ 13 from the FPU.

Well, on the PIIX it is and I guess on anything where it's _not_ fully 
internal an 0xf0 write wouldn't have any effect on IRQ13...

When you earlier mentioned this it seemed 0xed switched on DMI would be good 
enough, but well.

Alan, do you have an opinion on the port 0xf0 write? It should probably 
still be combined with a replacement/deletion for new machines due to the 
bus-locking "bad for real-time" thing you mentioned earlier but in the short 
run it could be a fairly low-impact replacement on anything except a 386+387

We should do a another timing measurement survey and it makes for sligtly 
worse code if we indeed feel it's not safe enough to write anything other 
than 0, but otherwise it's quite minimal.

Rene.

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/