Re: [patch 0/2] serial: explicitly request ttyS0-3 for COM1-4

[Russell King]

On Thu, Jan 17, 2008 at 09:07:29AM -0700, Bjorn Helgaas wrote:
> On Wednesday 16 January 2008 01:14:38 pm Russell King wrote:
> > On Wed, Jan 16, 2008 at 12:59:27PM -0700, Bjorn Helgaas wrote:
> > > On Wednesday 16 January 2008 11:39:34 am Russell King wrote:
> > > > On Wed, Jan 16, 2008 at 10:05:41AM -0700, Bjorn Helgaas wrote:
> > > > > When 8250_pnp discovers COM ports, we only get the correct ttyS names
> > > > > by accident -- we rely on serial8250_isa_init_ports(), which discovers
> > > > > the COM ports earlier using the addresses in SERIAL_PORT_DFNS.
> > > > 
> > > > It's not by accident but by design.  It's quite intentional that it
> > > > remembers the addresses of serial ports, and if another port is
> > > > registered later with the same base address, it gets the same name.
> > > 
> > > It's certainly by design that if we register a port twice, it gets
> > > the same name both times.
> > 
> > Incorrect - if it's not detected first time around (eg, the port isn't
> > accessible at that time), its slot will still be reserved due to the
> > way slots are given out.
> > 
> > Slots are given to users in order of:
> > 
> > 1. does the IO type and base address of a previously known port match
> >    the new port?  If so, use that.
> > 2. do we have a slot which has never been used - use that.
> > 3. find the first slot which is not currently in use.
> > 
> > So, the only way we'd get the first set of ttyS slots used is if all of
> > the following are true:
> > 
> > a) the ISA probe doesn't detect them
> > b) some other driver registers many ports which don't correspond with any
> >    of the ISA listed addresses and we run out of empty slots
> > c) 8250_pnp initialises after this driver
> > 
> > (c) is unlikely, except in the modular case - we explicitly list 8250_pnp
> > immediately after the 8250 driver so that it gets first call on the
> > slots during initialisation time, before we probe for PCI devices.
> 
> Let me back up a minute.  I was merely trying to make the point that
> if we skip the ISA probe (which uses SERIAL_PORT_DFNS), the 8250_pnp
> probe will discover the COM ports but won't necessarily name them the
> way we expect (e.g., http://lkml.org/lkml/2007/8/10/409).

It would be useful to see the full kernel messages to diagnose what's
going on.  Given that there's no changes to the serial probing code
(or even the code which allocates slots) there's something fishy going
on.  Are they using mainline kernels or do the kernels they're using
have some other changes which aren't in mainline?

-- 
Russell King
 Linux kernel    2.6 ARM Linux   - http://www.arm.linux.org.uk/
 maintainer of:
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/