Re: [drivers/net/bnx2.c] ADVERTISE_1000XPSE_ASYM

[Michael Chan]

On Wed, 2008-01-30 at 15:07 +0100, Roel Kluin wrote:
> In drivers/net/bnx2.c:1285: it reads in function bnx2_setup_remote_phy():
> 
> if (pause_adv & (ADVERTISE_1000XPSE_ASYM | ADVERTISE_1000XPSE_ASYM))
> 
> Note that the two are the same and this is therefore equivalent to
> 
> if (pause_adv & ADVERTISE_1000XPSE_ASYM)
> 
> This appears to be incorrect, was maybe '| ADVERTISE_1000XPAUSE' intended?
> 

Thanks for catching this.  The patch below will fix it.

[BNX2]: Fix ASYM PAUSE advertisement for remote PHY.

We were checking for the ASYM_PAUSE bit for 1000Base-X twice instead
checking for both the 1000Base-X bit and the 10/100/1000Base-T bit.
The purpose of the logic is to tell the firmware that ASYM_PAUSE is
set on either the Serdes or Copper interface.

Problem was discovered by Roel Kluin <12o3l@xxxxxxxxxx>

Signed-off-by: Michael Chan <mchan@xxxxxxxxxxxx>

diff --git a/drivers/net/bnx2.c b/drivers/net/bnx2.c
index be7e8f8..77400ad 100644
--- a/drivers/net/bnx2.c
+++ b/drivers/net/bnx2.c
@@ -1429,7 +1429,7 @@ bnx2_setup_remote_phy(struct bnx2 *bp, u8 port)
 
 	if (pause_adv & (ADVERTISE_1000XPAUSE | ADVERTISE_PAUSE_CAP))
 		speed_arg |= BNX2_NETLINK_SET_LINK_FC_SYM_PAUSE;
-	if (pause_adv & (ADVERTISE_1000XPSE_ASYM | ADVERTISE_1000XPSE_ASYM))
+	if (pause_adv & (ADVERTISE_1000XPSE_ASYM | ADVERTISE_PAUSE_ASYM))
 		speed_arg |= BNX2_NETLINK_SET_LINK_FC_ASYM_PAUSE;
 
 	if (port == PORT_TP)


--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/