Re: Unknown SATA PIIX PCI device ID 0x29b6

[Tejun Heo]

Guennadi Liakhovetski wrote:
> On Sun, 9 Mar 2008, Tejun Heo wrote:
> 
>> Guennadi Liakhovetski wrote:
>>> On Fri, 7 Mar 2008, Tejun Heo wrote:
>>>
>>>>> Looks like almost a minute to me? On another occurence I see about 1.5 
>>>>> minutes, then "port is slow to respond, please be patient (Status 0x80)" 
>>>>> has been repeated 3 times. On cold-plug also 3 times, I think, about the 
>>>>> same time then (time is not updated in the log).
>>>> I see.  Does the attached patch make any difference?
>>> diff --git a/drivers/ata/libata-core.c b/drivers/ata/libata-core.c
>>> index 4fbcce7..abebdcc 100644
>>> --- a/drivers/ata/libata-core.c
>>> +++ b/drivers/ata/libata-core.c
>>> @@ -6712,6 +6712,7 @@ int sata_link_init_spd(struct ata_link *link)
>>>  	spd = (scontrol >> 4) & 0xf;
>>>  	if (spd)
>>>  		link->hw_sata_spd_limit &= (1 << spd) - 1;
>>> +	link->hw_sata_spd_limit = 1;
>>>  
>>>  	ata_force_spd_limit(link);
>>>  
>>> Hm, this would force 1.5Gbps on all ports and devices, right? Cannot I 
>>> just boot with "libata.force=4:1.5Gbps"?
>> Yeap, you can do that.  Wasn't sure you were using .25-rc or .24.
> 
> Yctually it was 2.6.24 before, rebuilt 2.6.25-rc4, booted as above, it did 
> say:
> 
> ata4: FORCE: PHY spd limit set to 1.5Gbps
> 
> but hot-plugging the drive still took 50 seconds to recover.

How about cold plugging?

-- 
tejun
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/