Re: [PATCH] firewire: fw-ohci: sync AT dma buffer before use

[David Moore]

On Wed, 2008-03-12 at 17:43 -0400, Jarod Wilson wrote:
> diff --git a/drivers/firewire/fw-ohci.c b/drivers/firewire/fw-ohci.c
> index 081a434..fc45868 100644
> --- a/drivers/firewire/fw-ohci.c
> +++ b/drivers/firewire/fw-ohci.c
> @@ -780,6 +780,10 @@ at_context_queue_packet(struct context *ctx, struct fw_packet *packet)
>  
>  	context_append(ctx, d, z, 4 - z);
>  
> +	/* Sync the DMA buffer up for the device to read from */
> +	dma_sync_single_for_device(ohci->card.device, payload_bus,
> +				   packet->payload_length, DMA_TO_DEVICE);
> +
>  	/* If the context isn't already running, start it up. */
>  	reg = reg_read(ctx->ohci, CONTROL_SET(ctx->regs));
>  	if ((reg & CONTEXT_RUN) == 0)
> 

Two things:

1. The dma_sync should probably be done before the context_append
because the controller could in theory start reading the data as soon as
context_append is called right?

2. As an optimization, we should attempt to allocate the payload in the
lower 32-bits of physical memory, to prevent extra memcopies on x86_64.
I think this can be done by adding GFP_DMA32 to kmalloc where the
payload was allocated in fw-cdev.c.  There might be other places where
we would benefit from GFP_DMA32 also.  Of course, these optimizations
are probably better saved for another patch.

-David

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/