Re: [RFC PATCH 0/4] Describe SPI devices in the OF device tree and add mpc5200-spi driver

[Grant Likely]

On Fri, May 16, 2008 at 3:25 PM, Jon Smirl <jonsmirl@xxxxxxxxx> wrote:
> On 5/16/08, Grant Likely <grant.likely@xxxxxxxxxxxx> wrote:
>> On Fri, May 16, 2008 at 2:27 PM, Jon Smirl <jonsmirl@xxxxxxxxx> wrote:
>>  > On 5/16/08, Grant Likely <grant.likely@xxxxxxxxxxxx> wrote:
>>  >> This series is a set of changes to allow the slaves on an SPI bus to be
>>  >>  described in the OF device tree (useful in arch/powerpc) and adds a driver
>>  >>  that uses it (the Freescale MPC5200 SoC's SPI device).
>>  >
>>  > Right now we have SPI hooked up to PSC3. Hardware engineer is gone but
>>  > I'll see if I can get him to alter things to use the SPI controller. I
>>  > have an old mail from him where he thinks the Phytec board is missing
>>  > a signal needed to use the SPI controller.
>>
>>
>> While I'd appreciate the testing, I suspect that you really don't want
>>  to do that.  The dedicated SPI controller isn't very good.  It only
>>  does a byte at a time and so is rather slow.  A PSC is SPI mode should
>>  be better (but I haven't tried it personally it yet).
>
> What is the device tree node for PSC3 supposed to look like when it
> has both serial and spi enabled?

The *PSC3 device* cannot support both serial and SPI at the same time.
 Only one mode works at a time...

However, *PSC3 pin group* has can be configured to route both the
*PSC3 device* and the *SPI device* signal out to the board at the same
time.

Pin routing is not something that is described by the device tree.
It's viewed as a board level initialization thing, similar to how DDR
RAM initialization is viewed.  Ideally, the bootloader will write the
correct value into port_config for pin routing and Linux will never
need to touch it.  If the bootloader cannot be changed, then
board-specific platform code can be added to fixup the port_config
setting.  However, the drivers should never touch or care about pin
routing.

Cheers,
g.

-- 
Grant Likely, B.Sc., P.Eng.
Secret Lab Technologies Ltd.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/