SD-MMC over SPI on PSC6

[Fabio Tosetto]

Hello, I have an embedded system with an on-board processor powerpc 
MPC5200B
and Linux kernel 2.6.22,
I must turn over to MMC SPI on the PSC6.

The MMC over SPI is connected to MPC5200b, here's how:

 MPC5200B
----------------                                        
                      
|                                                                 
|------------------
        PSC1_2 |--->------------Chip_Select (out)---------|      
                      
|                                                                 |
                      |                        
                                        |     SD CARD
        ETH_17 |---<------------IRQ (in)------------------|   MMC over SPI
                      |                                                
                |
                      
|                                                                 |
        PSC6_0 |---<------------SPI_RXD (in)------------|
                      
|                                                                 |
                      
|                                                                 |
        PSC6_2 |--->------------SPI_TXD (out)-----------|
                      |                                                 
               |
                      |                                                 
               |
        PSC6_3 |--->------------SPI_CLK (out)-----------|
                      
|                                                                 
|------------------
----------------

Now on the menuconfig enabling these options:

$ make ARCH=powerpc CROSS_COMPILE=powerpc-linux-gnu- menuconfig

Platform support  --->
  [*] MPC5200 (L25R) bugfix support
  [*] Freescale Lite5200 Eval Board

Device Drivers  ---> SPI Support --->
  [*] SPI support
 <*> Freescale MPC52xx PSC SPI controller

Now I have applied those patch:
http://www.mail-archive.com/spi-devel-general@xxxxxxxxxxxxxxxxxxxxx/msg00150.html

Now on the menuconfig enabling these options:

$ make ARCH=powerpc CROSS_COMPILE=powerpc-linux-gnu- menuconfig

Device Drivers  --->  MMC/SD card support --->
[*] MMC debugging
<*> MMC block device driver
<*> MMC host test driver
<*> MMC/SD over SPI

Is correct applied those patch and enable those options into menuconfig?

thanks Fabio
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/