Re: linux-next: Tree for June 13: IO APIC breakage on HP nx6325

[Rafael J. Wysocki]

On Wednesday, 18 of June 2008, Maciej W. Rozycki wrote:
> On Wed, 18 Jun 2008, Rafael J. Wysocki wrote:
> 
> > Here you go.  Below is the relevant snippet from the yesterday's linux-next
> > dmesg with the patches:
> > "x86: I/O APIC: timer through 8259A second-chance"
> > "x86: add C1E aware idle function"
> > reverted and the appended debug patch applied.
> > 
> > [    0.108006] TIMER: vector=0x30 apic1=0 pin1=2 apic2=-1 pin2=-1
> > [    0.108006] ..MP-BIOS bug: 8254 timer not connected to IO-APIC
> > [    0.108006] ...trying to set up timer (IRQ0) through the 8259A ... <2> failed
> > [    0.108006] ...trying to set up timer as Virtual Wire IRQ...<2> works.
> > 
> > The entire dmesg is at: http://www.sisk.pl/kernel/debug/20080616/dmesg-4.log
> 
>  Thanks -- this is very important and useful information as it shows the
> exact alternative used.
> 
>  With such a configuration the "x86: I/O APIC: timer through 8259A
> second-chance" patch should not matter, because the only change it
> introduces is an attempt to try the same I/O APIC pin again, but with the
> IRQ0 line of the master 8259A enabled.  That's not a terribly unusual 
> configuration and nothing should get confused in the system.

But it _does_ get confused, really.

>  Barring the unlikely possibility of the 8259A actually being wired to 
> INTIN2 of the I/O APIC I can see two possible explanations:
> 
> 1. The 8259A interrupt actually escapes to the CPU somehow and is handled
>    as an ExtINTA interrupt.  This would make the code in check_timer()  
>    decide it has found a working configuration, while actually it has been
>    fooled.
> 
> 2. There is a bug in this patch or an assumption it makes which results 
>    in the state of some component not to be restored correctly.  
>    Unfortunately I have no resources to test the 64-bit variation of the 
>    code, so something may have escaped my attention.
> 
>  I'd like to find out which one is the case -- can you please reapply the
> patch and send me the corresponding section of the bootstrap log?  If the
> system hangs before you can retrieve the log, please just place:

Here you go:

[    0.108006] ..TIMER: vector=0x30 apic1=0 pin1=2 apic2=-1 pin2=-1
[    0.108006] ..MP-BIOS bug: 8254 timer not connected to IO-APIC
[    0.108006] ...trying to set up timer (IRQ0) through the 8259A ... <3>
[    0.108006] ..... (found apic 0 pin 2) ...<3> works.

The full dmesg is at: http://www.sisk.pl/kernel/debug/20080618/dmesg-1.log

Thanks,
Rafael
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/