* Factor out disabling of "fast interrupt" prediction from
init_hwif_hpt366() to hpt3xx_disable_fast_irq() helper.
* Use hpt3xx_disable_fast_irq() in ->init_chipset instead of
->init_hwif method.
This is a preparation for adding proper PCI PM support.
While at it:
* Cache chip type in chip_type variable in hpt3xx_disable_fast_irq().
There should be no functional changes caused by this patch.
Cc: Sergei Shtylyov <sshtylyov@xxxxxxxxxxxxx>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@xxxxxxxxx>
Index: b/drivers/ide/pci/hpt366.c
===================================================================
--- a/drivers/ide/pci/hpt366.c
+++ b/drivers/ide/pci/hpt366.c
@@ -1265,7 +1297,6 @@ static void __devinit init_hwif_hpt366(i
struct hpt_info *info = host->host_priv + (hwif->dev == host->dev[1]);
int serialize = HPT_SERIALIZE_IO;
u8 chip_type = info->chip_type;
- u8 new_mcr, old_mcr = 0;
/* Cache the channel's MISC. control registers' offset */
hwif->select_data = hwif->channel ? 0x54 : 0x50;
@@ -1288,29 +1319,6 @@ static void __devinit init_hwif_hpt366(i
/* Serialize access to this device if needed */
if (serialize && hwif->mate)
hwif->serialized = hwif->mate->serialized = 1;
-
- /*
- * Disable the "fast interrupt" prediction. Don't hold off
- * on interrupts. (== 0x01 despite what the docs say)
- */
- pci_read_config_byte(dev, hwif->select_data + 1, &old_mcr);
-
- if (info->chip_type >= HPT374)
- new_mcr = old_mcr & ~0x07;
- else if (info->chip_type >= HPT370) {
- new_mcr = old_mcr;
- new_mcr &= ~0x02;
-
-#ifdef HPT_DELAY_INTERRUPT
- new_mcr &= ~0x01;
-#else
- new_mcr |= 0x01;
-#endif
- } else /* HPT366 and HPT368 */
- new_mcr = old_mcr & ~0x80;
-
- if (new_mcr != old_mcr)
- pci_write_config_byte(dev, hwif->select_data + 1, new_mcr);
}