[PATCH 09/25] Blackfin: fix accidental reset in some boot modes

[Mike Frysinger]

From: Sonic Zhang <sonic.zhang@xxxxxxxxxx>

We read the SWRST (Software Reset) register to get at the last reset
state, and then we may configure the DOUBLE_FAULT bit to control behavior
when a double fault occurs.  But if the lower bits of the register is
already set (like UART boot mode on a BF54x), we inadvertently make the
system reset by writing to the SYSTEM_RESET field at the same time.  So
make sure the lower 4 bits are always cleared.

Signed-off-by: Sonic Zhang <sonic.zhang@xxxxxxxxxx>
Signed-off-by: Mike Frysinger <vapier@xxxxxxxxxx>
---
 arch/blackfin/kernel/setup.c |    3 ++-
 1 files changed, 2 insertions(+), 1 deletions(-)

diff --git a/arch/blackfin/kernel/setup.c b/arch/blackfin/kernel/setup.c
index 6454bab..b2782ea 100644
--- a/arch/blackfin/kernel/setup.c
+++ b/arch/blackfin/kernel/setup.c
@@ -837,7 +837,8 @@ void __init setup_arch(char **cmdline_p)
     defined(CONFIG_BF538) || defined(CONFIG_BF539)
 	_bfin_swrst = bfin_read_SWRST();
 #else
-	_bfin_swrst = bfin_read_SYSCR();
+	/* Clear boot mode field */
+	_bfin_swrst = bfin_read_SYSCR() & ~0xf;
 #endif
 
 #ifdef CONFIG_DEBUG_DOUBLEFAULT_PRINT
-- 
1.6.3.1

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/