[PATCH 2/2] drivers/media/dvb/dvb-usb/dib0700: CodingStyle fixes
From: Daniel Mack
Date: Mon May 24 2010 - 06:58:10 EST
Signed-off-by: Daniel Mack <daniel@xxxxxxxx>
Cc: Wolfram Sang <w.sang@xxxxxxxxxxxxxx>
Cc: Mauro Carvalho Chehab <mchehab@xxxxxxxxxxxxx>
Cc: Jiri Slaby <jslaby@xxxxxxx>
Cc: Dmitry Torokhov <dtor@xxxxxxx>
Cc: Devin Heitmueller <dheitmueller@xxxxxxxxxxxxxx>
Cc: linux-media@xxxxxxxxxxxxxxx
---
drivers/media/dvb/dvb-usb/dib0700_core.c | 66 ++++++++++++++++--------------
1 files changed, 35 insertions(+), 31 deletions(-)
diff --git a/drivers/media/dvb/dvb-usb/dib0700_core.c b/drivers/media/dvb/dvb-usb/dib0700_core.c
index d2dabac..45aec3a 100644
--- a/drivers/media/dvb/dvb-usb/dib0700_core.c
+++ b/drivers/media/dvb/dvb-usb/dib0700_core.c
@@ -53,7 +53,7 @@ static int dib0700_ctrl_wr(struct dvb_usb_device *d, u8 *tx, u8 txlen)
int status;
deb_data(">>> ");
- debug_dump(tx,txlen,deb_data);
+ debug_dump(tx, txlen, deb_data);
status = usb_control_msg(d->udev, usb_sndctrlpipe(d->udev,0),
tx[0], USB_TYPE_VENDOR | USB_DIR_OUT, 0, 0, tx, txlen,
@@ -98,7 +98,7 @@ int dib0700_ctrl_rd(struct dvb_usb_device *d, u8 *tx, u8 txlen, u8 *rx, u8 rxlen
deb_info("ep 0 read error (status = %d)\n",status);
deb_data("<<< ");
- debug_dump(rx,rxlen,deb_data);
+ debug_dump(rx, rxlen, deb_data);
return status; /* length in case of success */
}
@@ -106,28 +106,29 @@ int dib0700_ctrl_rd(struct dvb_usb_device *d, u8 *tx, u8 txlen, u8 *rx, u8 rxlen
int dib0700_set_gpio(struct dvb_usb_device *d, enum dib07x0_gpios gpio, u8 gpio_dir, u8 gpio_val)
{
u8 buf[3] = { REQUEST_SET_GPIO, gpio, ((gpio_dir & 0x01) << 7) | ((gpio_val & 0x01) << 6) };
- return dib0700_ctrl_wr(d,buf,3);
+ return dib0700_ctrl_wr(d, buf, sizeof(buf));
}
static int dib0700_set_usb_xfer_len(struct dvb_usb_device *d, u16 nb_ts_packets)
{
- struct dib0700_state *st = d->priv;
- u8 b[3];
- int ret;
-
- if (st->fw_version >= 0x10201) {
- b[0] = REQUEST_SET_USB_XFER_LEN;
- b[1] = (nb_ts_packets >> 8)&0xff;
- b[2] = nb_ts_packets & 0xff;
-
- deb_info("set the USB xfer len to %i Ts packet\n", nb_ts_packets);
-
- ret = dib0700_ctrl_wr(d, b, 3);
- } else {
- deb_info("this firmware does not allow to change the USB xfer len\n");
- ret = -EIO;
- }
- return ret;
+ struct dib0700_state *st = d->priv;
+ u8 b[3];
+ int ret;
+
+ if (st->fw_version >= 0x10201) {
+ b[0] = REQUEST_SET_USB_XFER_LEN;
+ b[1] = (nb_ts_packets >> 8) & 0xff;
+ b[2] = nb_ts_packets & 0xff;
+
+ deb_info("set the USB xfer len to %i Ts packet\n", nb_ts_packets);
+
+ ret = dib0700_ctrl_wr(d, b, 3);
+ } else {
+ deb_info("this firmware does not allow to change the USB xfer len\n");
+ ret = -EIO;
+ }
+
+ return ret;
}
/*
@@ -178,7 +179,8 @@ static int dib0700_i2c_xfer_new(struct i2c_adapter *adap, struct i2c_msg *msg,
value = ((en_start << 7) | (en_stop << 6) |
(msg[i].len & 0x3F)) << 8 | i2c_dest;
/* I2C ctrl + FE bus; */
- index = ((gen_mode<<6)&0xC0) | ((bus_mode<<4)&0x30);
+ index = ((gen_mode << 6) & 0xC0) |
+ ((bus_mode << 4) & 0x30);
result = usb_control_msg(d->udev,
usb_rcvctrlpipe(d->udev, 0),
@@ -198,11 +200,12 @@ static int dib0700_i2c_xfer_new(struct i2c_adapter *adap, struct i2c_msg *msg,
} else {
/* Write request */
buf[0] = REQUEST_NEW_I2C_WRITE;
- buf[1] = (msg[i].addr << 1);
+ buf[1] = msg[i].addr << 1;
buf[2] = (en_start << 7) | (en_stop << 6) |
(msg[i].len & 0x3F);
/* I2C ctrl + FE bus; */
- buf[3] = ((gen_mode<<6)&0xC0) | ((bus_mode<<4)&0x30);
+ buf[3] = ((gen_mode << 6) & 0xC0) |
+ ((bus_mode << 4) & 0x30);
/* The Actual i2c payload */
memcpy(&buf[4], msg[i].buf, msg[i].len);
@@ -240,7 +243,7 @@ static int dib0700_i2c_xfer_legacy(struct i2c_adapter *adap,
for (i = 0; i < num; i++) {
/* fill in the address */
- buf[1] = (msg[i].addr << 1);
+ buf[1] = msg[i].addr << 1;
/* fill the buffer */
memcpy(&buf[2], msg[i].buf, msg[i].len);
@@ -368,7 +371,8 @@ int dib0700_download_firmware(struct usb_device *udev, const struct firmware *fw
u8 buf[260];
while ((ret = dvb_usb_get_hexline(fw, &hx, &pos)) > 0) {
- deb_fwdata("writing to address 0x%08x (buffer: 0x%02x %02x)\n",hx.addr, hx.len, hx.chk);
+ deb_fwdata("writing to address 0x%08x (buffer: 0x%02x %02x)\n",
+ hx.addr, hx.len, hx.chk);
buf[0] = hx.len;
buf[1] = (hx.addr >> 8) & 0xff;
@@ -408,16 +412,16 @@ int dib0700_download_firmware(struct usb_device *udev, const struct firmware *fw
REQUEST_GET_VERSION,
USB_TYPE_VENDOR | USB_DIR_IN, 0, 0,
b, sizeof(b), USB_CTRL_GET_TIMEOUT);
- fw_version = (b[8] << 24) | (b[9] << 16) | (b[10] << 8) | b[11];
+ fw_version = (b[8] << 24) | (b[9] << 16) | (b[10] << 8) | b[11];
/* set the buffer size - DVB-USB is allocating URB buffers
* only after the firwmare download was successful */
for (i = 0; i < dib0700_device_count; i++) {
for (adap_num = 0; adap_num < dib0700_devices[i].num_adapters;
adap_num++) {
- if (fw_version >= 0x10201)
+ if (fw_version >= 0x10201) {
dib0700_devices[i].adapter[adap_num].stream.u.bulk.buffersize = 188*nb_packet_buffer_size;
- else {
+ } else {
/* for fw version older than 1.20.1,
* the buffersize has to be n times 512 */
dib0700_devices[i].adapter[adap_num].stream.u.bulk.buffersize = ((188*nb_packet_buffer_size+188/2)/512)*512;
@@ -453,7 +457,7 @@ int dib0700_streaming_ctrl(struct dvb_usb_adapter *adap, int onoff)
if (st->disable_streaming_master_mode == 1)
b[2] = 0x00;
else
- b[2] = (0x01 << 4); /* Master mode */
+ b[2] = 0x01 << 4; /* Master mode */
b[3] = 0x00;
@@ -466,7 +470,7 @@ int dib0700_streaming_ctrl(struct dvb_usb_adapter *adap, int onoff)
b[2] |= st->channel_state;
- deb_info("data for streaming: %x %x\n",b[1],b[2]);
+ deb_info("data for streaming: %x %x\n", b[1], b[2]);
return dib0700_ctrl_wr(adap->dev, b, 4);
}
@@ -631,7 +635,7 @@ resubmit:
int dib0700_rc_setup(struct dvb_usb_device *d)
{
struct dib0700_state *st = d->priv;
- u8 rc_setup[3] = {REQUEST_SET_RC, dvb_usb_dib0700_ir_proto, 0};
+ u8 rc_setup[3] = { REQUEST_SET_RC, dvb_usb_dib0700_ir_proto, 0 };
struct urb *purb;
int ret;
int i;
--
1.7.1
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/