[PATCH 2/2] pch_uart: revert Kconfig for non-DMA mode

[Tomoya MORINAGA]

PCH_DMA is not always enabled when a user uses PCH_UART.
Since overhead of DMA is not small, in case of low frequent communication,
without DMA is better.
Thus, "select PCH_DMA" and DMADEVICES are unnecessary

Signed-off-by: Tomoya MORINAGA <tomoya-linux@xxxxxxxxxxxxxxx>
---
 drivers/serial/Kconfig |    5 ++---
 1 files changed, 2 insertions(+), 3 deletions(-)

diff --git a/drivers/serial/Kconfig b/drivers/serial/Kconfig
index 3d836f0..58847e9 100644
--- a/drivers/serial/Kconfig
+++ b/drivers/serial/Kconfig
@@ -1587,10 +1587,9 @@ config SERIAL_IFX6X60
 	  Support for the IFX6x60 modem devices on Intel MID platforms.
 
 config SERIAL_PCH_UART
-	tristate "Intel EG20T PCH UART"
-	depends on PCI && DMADEVICES
+	tristate "Intel EG20T PCH UART/OKI SEMICONDUCTOR ML7213 IOH"
+	depends on PCI
 	select SERIAL_CORE
-	select PCH_DMA
 	help
 	  This driver is for PCH(Platform controller Hub) UART of Intel EG20T
 	  which is an IOH(Input/Output Hub) for x86 embedded processor.
-- 
1.6.2.5

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/