Re: [PATCH RFC] x86: avoid atomic operation intest_and_set_bit_lock if possible

[Peter Zijlstra]

On Sat, 2011-03-26 at 09:15 +0100, Eric Dumazet wrote:
> Le vendredi 25 mars 2011 Ã 21:29 +0100, Peter Zijlstra a Ãcrit :
> > On Fri, 2011-03-25 at 10:38 +0100, Eric Dumazet wrote:
> > > 
> > > BIOS :  Version: I27  Release Date: 09/30/2010
> > > 
> > > [    0.021849] CPU0: Intel(R) Xeon(R) CPU           E5640  @ 2.67GHz stepping 02
> > > [    0.123904] Performance Events: PEBS fmt1+, Westmere events, Broken BIOS detected, using software events only.
> > > [    0.124125] [Firmware Bug]: the BIOS has corrupted hw-PMU resources (MSR 38d is 330) 
> > 
> > Do the below instructions yield a working system?:
> > 
> > > > On the BL460c G6/G7, one could perform the following steps:
> > > >
> > > > To configure BIOS low-latency options using RBSU
> > > > 1. Press F9 during POST to enter RBSU.
> > > > 2. Press CTRL-A to open the menu.
> > > > 3. Select Service Options.
> > > > 4. Disable either or both of the following options:
> > > > o Processor Power and Utilization Monitoring
> > > > o Memory Pre-Failure Notification
> > > > 
> > > > By doing the above the BIOS should release the performance counter, and the
> > > > kernel's "perf" should not encounter a conflict. 
> > > > 
> > > > The document that you are looking for is here: (please see page 8 and later):
> > > > http://h20000.www2.hp.com/bc/docs/support/SupportManual/c01804533/c01804533.pdf
> > 
> > 
> > 
> 
> Thanks Peter !
> 
> I was not aware of the hidden "CTRL-A" feature on RBSU, so I never met
> these configuration settings ("Service Options" added in main menu)
> 
> I already was in "Power regulator mode : Static High mode"
> QPI Link power management : Disabled
> 
> I have latest released I24 BIOS
> DMI: HP ProLiant BL460c G6, BIOS I24 01/29/2011
> 
> 1) I disabled "Power and Utilization Monitoring" _and_ "Memory
> Pre-Failure Notification"
> 
> Still I got the 'MSR 38d is 330' error
> 
> 2) I then disabled Intel Turbo boost
> 
> Same error
> 
> 3) Minimum Processor idle Power state
>   From C1E-State --> No C-states
> 
> Same error
> 
> Tricky isnt it ?

Definitely, OK thanks for testing, I'll contact HP again.

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/