Re: Linux 2.6.39

[Ville Tervo]

On Wed, May 25, 2011 at 09:11:19PM -0400, ext Corey Boyle wrote:
> On Wed, May 25, 2011 at 12:31 PM, Tom Allebrandi <wyrles@xxxxxxxxx> wrote:
> > -----Original Message-----
> > From: linux-bluetooth-owner@xxxxxxxxxxxxxxx
> > [mailto:linux-bluetooth-owner@xxxxxxxxxxxxxxx] On Behalf Of Cufi, Carles
> > Sent: Wednesday, May 25, 2011 7:15 AM
> > To: corey@xxxxxxxxxxxxx
> > Cc: Ed Tomlinson; Ville Tervo; Bluettooth Linux;
> > linux-kernel@xxxxxxxxxxxxxxx
> > Subject: RE: Linux 2.6.39
> >
> > (Snipping...)
> > On Wed, May 25, 2011 at 8:46 AM, Cufi, Carles <carles.cufi@xxxxxxxxxxxxx>
> > wrote:
> >> On Wednesday 25 May 2011 07:36:14 Ville Tervo wrote:
> >>> On Wed, May 25, 2011 at 07:11:17AM -0400, ext Ed Tomlinson wrote:
> >>> > On Wednesday 25 May 2011 06:54:54 Corey Boyle wrote:
> >>> > > > On Mon, May 23, 2011 at 06:08:36PM -0400, ext Ed Tomlinson wrote:
> >>> > > > > On Saturday 21 May 2011 16:31:00 Ed Tomlinson wrote:
> >>> > > > > > On Saturday 21 May 2011 13:56:20 Milan Oravec wrote:
> > ...
> >>> > Read Local Version Information (0x04|0x0001) plen 0
> >>> > > HCI Event: Command Complete (0x0e) plen 12
> >>> >     Read Local Version Information (0x04|0x0001) ncmd 1
> >>> >     status 0x00
> >>> >     HCI Version: 1.1 (0x1) HCI Revision: 0x20d
> > *************************
> >>> >     LMP Version: 1.1 (0x1) LMP Subversion: 0x20d
> > *************************
> >>> >     Manufacturer: Cambridge Silicon Radio (10) < HCI Command: Set
> >>> > Event Mask (0x03|0x0001) plen 8
> >>> >     Mask: 0xfffffbff00000000
> > *************************
> >>> > > HCI Event: Command Complete (0x0e) plen 4
> >>> >     Set Event Mask (0x03|0x0001) ncmd 1
> >>> >     status 0x12
> >>> >     Error: Invalid HCI Command Parameters
> >>
> >>Set Event Mask has been in the Bluetooth Spec since day 1, so it must be
> > the bitmask, which has been extended with each new spec release to cover
> > newly >added events. Looking at the latest spec, and judging by the year
> > your chipset was released in (it probably is a 1.1 compliant chipset) I
> > believe that >0x000000008FFFFFFF is the highest event mask it would support
> > (up until and including Page Scan Repetition Mode Change Event), but since I
> > don't have the >old 1.1 spec around I may be one or two bits off.
> >
> > The device appears to have identified itself as CSR firmware using Bluetooth
> > version 1.1.
> >
> > I do happen to have the 1.1 spec lying around :-), for Set_Event_Mask it
> > says
> >
> > 0x0000000100000000
> > To                                          Reserved for future use
> > 0x8000000000000000
> >
> > 0x00000000FFFFFFFF      Default (All events enabled)
> >
> 
> I am beginning to think that my adapter simply does not support this
> command.  I have tried with all the suggested bitmasks, all zeros, all
> ones, all combinations where a single bit is set, etc.  I'm not sure
> where to go from here other than add a flag which incidates that
> certain devices don't support this command so it can be skipped.
> Again, the only way I have gotten it to work is by not sending the
> command at all.  Thoughts?

I also played a bit with 1.1 CSR dongle and couldn't find any mask that would
be accepted. I think this command can be left out for older than 1.2 devices.

Following patch should do it. Could you verify it. I don't have access to old
hw ATM.

diff --git a/net/bluetooth/hci_event.c b/net/bluetooth/hci_event.c
index 19cd4af..86d1e26 100644
--- a/net/bluetooth/hci_event.c
+++ b/net/bluetooth/hci_event.c
@@ -477,14 +477,16 @@ static void hci_setup_event_mask(struct hci_dev *hdev)
 	 * command otherwise */
 	u8 events[8] = { 0xff, 0xff, 0xfb, 0xff, 0x00, 0x00, 0x00, 0x00 };
 
-	/* Events for 1.2 and newer controllers */
-	if (hdev->lmp_ver > 1) {
-		events[4] |= 0x01; /* Flow Specification Complete */
-		events[4] |= 0x02; /* Inquiry Result with RSSI */
-		events[4] |= 0x04; /* Read Remote Extended Features Complete */
-		events[5] |= 0x08; /* Synchronous Connection Complete */
-		events[5] |= 0x10; /* Synchronous Connection Changed */
-	}
+	/* CSR 1.1 dongles does not accept any bitfield so don't try to set
+	 * any event mask for pre 1.2 devices */
+	if (hdev->lmp_ver <= 1)
+		return;
+
+	events[4] |= 0x01; /* Flow Specification Complete */
+	events[4] |= 0x02; /* Inquiry Result with RSSI */
+	events[4] |= 0x04; /* Read Remote Extended Features Complete */
+	events[5] |= 0x08; /* Synchronous Connection Complete */
+	events[5] |= 0x10; /* Synchronous Connection Changed */
 
 	if (hdev->features[3] & LMP_RSSI_INQ)
 		events[4] |= 0x04; /* Inquiry Result with RSSI */
-- 

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/