[PATCH 1/1] AT91: flexibity: default leds to heartbeat

[Maxim Osipov]

This patch changes default behavior of Flexibity board LEDs to blinking
for boot diagnostic purpose.

Signed-off-by: Maxim Osipov <maxim.osipov@xxxxxxxxx>
---
 arch/arm/mach-at91/board-flexibity.c |   16 ++++++++--------
 1 files changed, 8 insertions(+), 8 deletions(-)

diff --git a/arch/arm/mach-at91/board-flexibity.c b/arch/arm/mach-at91/board-flexibity.c
index 4fdc96c..8cbec8a 100644
--- a/arch/arm/mach-at91/board-flexibity.c
+++ b/arch/arm/mach-at91/board-flexibity.c
@@ -96,49 +96,49 @@ static struct gpio_led flexibity_leds[] = {
 		.name			= "usb1:green",
 		.gpio			= AT91_PIN_PA12,
 		.active_low		= 1,
-		.default_trigger	= "default-on",
+		.default_trigger	= "heartbeat",
 	},
 	{
 		.name			= "usb1:red",
 		.gpio			= AT91_PIN_PA13,
 		.active_low		= 1,
-		.default_trigger	= "default-on",
+		.default_trigger	= "heartbeat",
 	},
 	{
 		.name			= "usb2:green",
 		.gpio			= AT91_PIN_PB26,
 		.active_low		= 1,
-		.default_trigger	= "default-on",
+		.default_trigger	= "heartbeat",
 	},
 	{
 		.name			= "usb2:red",
 		.gpio			= AT91_PIN_PB27,
 		.active_low		= 1,
-		.default_trigger	= "default-on",
+		.default_trigger	= "heartbeat",
 	},
 	{
 		.name			= "usb3:green",
 		.gpio			= AT91_PIN_PC8,
 		.active_low		= 1,
-		.default_trigger	= "default-on",
+		.default_trigger	= "heartbeat",
 	},
 	{
 		.name			= "usb3:red",
 		.gpio			= AT91_PIN_PC6,
 		.active_low		= 1,
-		.default_trigger	= "default-on",
+		.default_trigger	= "heartbeat",
 	},
 	{
 		.name			= "usb4:green",
 		.gpio			= AT91_PIN_PB4,
 		.active_low		= 1,
-		.default_trigger	= "default-on",
+		.default_trigger	= "heartbeat",
 	},
 	{
 		.name			= "usb4:red",
 		.gpio			= AT91_PIN_PB5,
 		.active_low		= 1,
-		.default_trigger	= "default-on",
+		.default_trigger	= "heartbeat",
 	}
 };
 
-- 
1.7.4.1

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/