re: mfd: Simulate active high IRQs with wm831x

[Dan Carpenter]

Hi Mark,

Smatch complains about d71820b8a8fbe9 "mfd: Simulate active high IRQs
with wm831x"

drivers/mfd/wm831x-irq.c +522 wm831x_irq_thread(67)
	error: buffer overflow 'wm831x->gpio_level' 16 <= 56

   518                  /* Simulate an edge triggered IRQ by polling the input
   519                   * status.  This is sucky but improves interoperability.
   520                   */
   521                  if (primary == WM831X_GP_INT &&
   522                      wm831x->gpio_level[i - WM831X_IRQ_GPIO_1]) {
                            ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
   523                          ret = wm831x_reg_read(wm831x, WM831X_GPIO_LEVEL);
   524                          while (ret & 1 << (i - WM831X_IRQ_GPIO_1)) {
   525                                  handle_nested_irq(wm831x->irq_base + i);
   526                                  ret = wm831x_reg_read(wm831x,
   527                                                        WM831X_GPIO_LEVEL);
   528                          }
   529                  }

We're inside a for loop over ARRAY_SIZE(wm831x_irqs) which has 58
elements (so "i" is 0-57) and we subtract WM831X_IRQ_GPIO_1 (1) which
gives us a max of 56.  The ->gpio_level[] array only has 16 elements
so we're reading beyond the end of the array.

In wm831x_irq_set_type() it only sets the first 11 elements of the
->gpio_level[] array.  Perhaps something similar is needed here.  I
don't know the code well enough to say.

regards,
dan carpenter
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/