[GIT PULL 1/13] arm-soc bug fixes

From: Arnd Bergmann
Date: Tue Nov 01 2011 - 22:23:01 EST

Next message: Arnd Bergmann: "[GIT PULL 3/13] arm-soc driver"
Previous message: Ted Ts'o: "Re: [PATCH -next] ext4: fix printk format warning in page-io"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Some bug fixes all over the places. These were mostly too minor to have
in the late 3.1 cycle, so I'm submitting them here. A part of this is
the initial set of 'randconfig' fixes, many more of these will come
in the future since I have over 100 trivial patches queued up in this
area. I'm planning to pick the important ones, plus any build regressions
and submit them after 3.2-rc1, but sorting through the large series will
take more time.

Arnd

The following changes since commit 839d8810747bbf39e0a5a7f223b67bffa7945f8d:

Merge branch 'i2c-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jdelvare/staging (2011-10-30 15:54:59 -0700)

are available in the git repository at:

git://git.linaro.org/people/arnd/arm-soc.git next/fixes
Arnaud Patard (2):
MX5: fix clock usage
ARM: mx5: fix clock usage for suspend

Arnd Bergmann (17):
Merge branch 'tegra/fixes' into next/fixes
Merge branch 'omap/fixes' into fixes
ARM: pxa: make zylonite_pxa*_init declaration match code
ARM: pxa: export symbols from pxa3xx-ulpi
ARM: pxa: allow selecting just one of TREO680/CENTRO
ARM: pxa: CPU_FREQ_TABLE is needed for CPU_FREQ
ARM: pxa: pxa95x is incompatible with earlier pxa
ARM: pxa: select POWER_SUPPLY on raumfeld
ARM: pxa: centro and treo680 need palm27x
ARM: pxa: sharpsl pm needs SPI
ARM: pxa: use correct __iomem annotations
Merge branch 'imx/fixes' into next/fixes
Merge branch 'fixes' into next/fixes
Merge branch 'imx/fixes' into next/fixes
Merge branch 'pxa/fixes' into next/fixes
Merge branch 'depends/rmk/gpio' into next/fixes
Merge branch 'depends/rmk/memory_h' into next/fixes

Axel Lin (1):
ARM: pxa/cm-x300: properly set bt_reset pin

Bjarne Steinsbo (1):
ARM: OMAP4: Keyboard: Fix section mismatch in the board file

Eric Miao (5):
ARM: pxa: fix building error by palm27x_lcd_init() when FB_PXA not defined
ARM: pxa/z2: fix building error of pxa27x_cpu_suspend() no longer available
ARM: pxa: pxa95x/saarb depends on pxa3xx code
ARM: pxa: make pxafb_smart_*() empty when not enabled
ARM: mmp: rename SHEEVAD to GPLUGD

Fabio Estevam (1):
ARM: mx31pdk: Fix build by passing IMX_HAVE_PLATFORM_MXC_MMC

Linus Walleij (1):
ARM: mach-ux500: unlock I&D l2x0 caches before init

Matt Burtch (1):
ARM: i.MX28: shift frac value in _CLK_SET_RATE

Nicolas Ferre (2):
ARM: at91: remove dependency for Atmel PWM driver selector in Kconfig
ARM: at91: add defconfig for at91sam9g45 family

Paul Bolle (1):
ARM: imx: Fix typo 'MACH_MX31_3DS_MXC_NAND_USE_BBT'

Paul Fertser (1):
plat-mxc: iomux-v3.h: implicitly enable pull-up/down when that's desired

Stephen Warren (1):
arm/dt: Tegra: Add support-8bit to SDHCI nodes

Tapani Utriainen (1):
ARM: OMAP: irq: loop counter fix in omap_init_irq()

srinidhi kasagar (1):
ARM: mach-ux500: enable fix for ARM errata 754322

arch/arm/Kconfig | 3 +-
arch/arm/boot/dts/tegra-harmony.dts | 1 +
arch/arm/boot/dts/tegra-seaboard.dts | 4 +
arch/arm/configs/at91sam9g45_defconfig | 214 +++++++++++++++++++++++++++++
arch/arm/include/asm/hardware/it8152.h | 2 +-
arch/arm/mach-imx/Kconfig | 1 +
arch/arm/mach-imx/mach-mx31_3ds.c | 2 +-
arch/arm/mach-mmp/Kconfig | 2 +-
arch/arm/mach-mmp/Makefile | 2 +-
arch/arm/mach-mmp/clock.h | 8 +-
arch/arm/mach-mmp/common.c | 4 +-
arch/arm/mach-mmp/gplugd.c | 2 +-
arch/arm/mach-mmp/include/mach/addr-map.h | 10 +-
arch/arm/mach-mmp/include/mach/gpio-pxa.h | 2 +-
arch/arm/mach-mmp/mmp2.c | 3 +-
arch/arm/mach-mx5/pm-imx5.c | 15 ++-
arch/arm/mach-mxs/clock-mx28.c | 2 +-
arch/arm/mach-omap2/board-4430sdp.c | 2 +-
arch/arm/mach-omap2/irq.c | 4 +-
arch/arm/mach-pxa/Kconfig | 38 ++++--
arch/arm/mach-pxa/Makefile | 2 +-
arch/arm/mach-pxa/balloon3.c | 10 +-
arch/arm/mach-pxa/cm-x2xx-pci.c | 2 +-
arch/arm/mach-pxa/cm-x2xx.c | 4 +-
arch/arm/mach-pxa/cm-x300.c | 8 +-
arch/arm/mach-pxa/include/mach/addr-map.h | 8 +-
arch/arm/mach-pxa/include/mach/balloon3.h | 2 +-
arch/arm/mach-pxa/include/mach/gpio-pxa.h | 2 +-
arch/arm/mach-pxa/include/mach/hardware.h | 9 +-
arch/arm/mach-pxa/include/mach/lpd270.h | 4 +-
arch/arm/mach-pxa/include/mach/mtd-xip.h | 1 -
arch/arm/mach-pxa/include/mach/palm27x.h | 2 +-
arch/arm/mach-pxa/include/mach/palmtx.h | 6 +-
arch/arm/mach-pxa/include/mach/pxa27x.h | 2 +
arch/arm/mach-pxa/include/mach/pxa95x.h | 7 +
arch/arm/mach-pxa/include/mach/pxafb.h | 13 ++
arch/arm/mach-pxa/include/mach/smemc.h | 2 +-
arch/arm/mach-pxa/include/mach/zeus.h | 4 +-
arch/arm/mach-pxa/include/mach/zylonite.h | 4 +-
arch/arm/mach-pxa/irq.c | 4 +-
arch/arm/mach-pxa/lpd270.c | 2 +-
arch/arm/mach-pxa/palmtreo.c | 8 +
arch/arm/mach-pxa/palmtx.c | 8 +-
arch/arm/mach-pxa/pxa25x.c | 2 +-
arch/arm/mach-pxa/pxa27x.c | 2 +-
arch/arm/mach-pxa/pxa3xx-ulpi.c | 2 +
arch/arm/mach-pxa/pxa3xx.c | 2 +-
arch/arm/mach-pxa/saarb.c | 1 +
arch/arm/mach-pxa/z2.c | 3 +-
arch/arm/mach-pxa/zeus.c | 8 +-
arch/arm/mach-ux500/cpu.c | 25 ++++-
arch/arm/plat-mxc/include/mach/iomux-v3.h | 10 +-
arch/arm/plat-pxa/include/plat/mfp.h | 2 +-
arch/arm/plat-pxa/mfp.c | 4 +-
drivers/gpio/gpio-pxa.c | 2 +-
drivers/misc/Kconfig | 2 +-
drivers/pcmcia/pxa2xx_balloon3.c | 2 +-
drivers/video/mbx/mbxfb.c | 6 +-
drivers/video/pxafb.c | 10 --
59 files changed, 410 insertions(+), 108 deletions(-)

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

Next message: Arnd Bergmann: "[GIT PULL 3/13] arm-soc driver"
Previous message: Ted Ts'o: "Re: [PATCH -next] ext4: fix printk format warning in page-io"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]