Re: [PATCH 0/3 v2] i2c: i801: enable irq

[Jean Delvare]

Hi Daniel,

On Fri,  6 Jan 2012 18:58:19 +0800, Daniel Kurtz wrote:
> This is a second version of a set of patches enables the Intel PCH SMBus
> controller interrupt.  It refactors the second two patches a little bit by
> relying on DEV_ERR interrupt for timeouts, instead of using an explicit
> wait_event_timeout.
> 
> The first attempt received absolutely no response. Maybe this time someone
> will be interested.

I was on vacation. But I am very interested and will review and test
your patches. There have been several attempts to add IRQ support to
i2c-i801 in the past but each time there was a blocker issue which
prevented it from making it into mainline. Hopefully this time we'll
get it there!

> 
> The SMBus Host Controller Interrupt can signify:
>  INTR - the end of a complete transaction
>  DEV_ERR - that a device did not ACK a transaction
>  BYTE_DONE - the completion of a single byte during a byte-by-byte transaction
> 
> This patchset arrives with the following caveats:
> 
>  1)  It has only been tested with a Cougar Point (Intel 6 Series PCH) SMBus
> controller, so the irq is only enabled for that chip type.

I can test on ICH10 easily, and also on ICH7 and ICH3-M if needed.

>  2) It has not been tested with any devices that do transactions that use the
>     PEC.  In fact, I believe that an additional small patch would be required
>     to the driver working correctly in interrupt mode with PEC.
> 
>  3) It has not been tested in SMBus Slave mode.
> 
>  4) It has not been tested with SMI#-type interrupts.
> 
>  5) The BIOS has to configure the PCH SMBus IRQ properly.
> 
>  6) It has not been tested with a device that does byte-by-byte smbus (non-i2c)
>     reads.

I think I can test this.

>  7) It has not been tested with smbus 'process call' transactions.

But not this.

> If would be very helpful if somebody could help test on other chipsets, with
> a PEC device, or on additional BIOS that woudl be very helpful.

I will do what I can with the hardware I have here.

> In the meantime, the interrupt behavior is only enabled on the Cougar Point,
> and even here, it can be completely disabled with the "Interrupt" feature like
> other advanced features of the driver.
> 
> Daniel Kurtz (3):
>   i2c: i801: refactor i801_block_transaction_byte_by_byte
>   i2c: i801: enable irq for i801 smbus transactions
>   i2c: i801: enable irq for byte_by_byte transactions
> 
>  drivers/i2c/busses/i2c-i801.c |  199 ++++++++++++++++++++++++++++++++++++-----
>  1 files changed, 175 insertions(+), 24 deletions(-)

-- 
Jean Delvare
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/