Re: [PATCH V1] TPS62360: Add tps62360 regulator driver

[Mark Brown]

On Thu, Jan 05, 2012 at 07:18:25PM +0530, Laxman Dewangan wrote:

Please fix your mailer to word wrap at less than 80 columns.  I've
reflowed your text for legibility.

> > > +	/* Configure the output discharge path */
> > > +	st = tps62360_reg_modify_bits(tps, REG_RAMPCTRL, BIT(2), BIT(2));
> > > +	if (st < 0)
> > > +		dev_err(tps->dev, "%s() fails in updating reg %d\n",
> > > +			__func__, REG_RAMPCTRL);
> > > +}

> > I rather suspect that if this is worth doing it's also worth doing over
> > suspend...

> The discharge path should be only enabled when the output voltage will go to 0.
> If it stay in non-zero voltage and enabling discharge path  will consume more power.
> In suspend, it is not necessarily that voltage output will be 0 and hence it should not
> be enabled. In shutdown all power goes off from pmu and hence it is worth to enable
> discharge path for quick fall of output voltage.

> > 
> > > + * @vsel: Select the voltage id register.
> > 
> > What's this?
> There is 4 sets of voltage configuration register for voltage output. The power
> on reset values for this registers are different and selection of the voltage
> configuration register is done by 2 pins of the pmu chip which is board dependent.
> Based on board connection, it need to be program the desired voltage configuration
> Register to achieve the desired output.
> 
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/