After commit "db8857b stmmac: use an unique MDIO bus name" my
device stopped being probed because two different names were being
used in different places. This fixes the inconsistency.
Signed-off-by: Alessandro Rubini<rubini@xxxxxxxxx>
Acked-by: Giancarlo Asnaghi<giancarlo.asnaghi@xxxxxx>
Cc: Giuseppe Cavallaro<peppe.cavallaro@xxxxxx>
Cc: Florian Fainelli<florian@xxxxxxxxxxx>
---
Before the commit, the phy was identified like this and stuff worked:
PHY ID 20005c90 at 1 IRQ 0 (506:01) active
After that commit, I get
PHY ID 20005c90 at 1 IRQ 0 (STMMAC MII Bus-1:01) active
PHY stmmac-1:01 not found
In one place, "stmmac" is a static string, on the other the commit
used the name field of the bus that was "STMMAC MII Bus", so I changed
this older string to be nicer -- without spaces.
Maybe the name is available where "stmmac" is spelled out, but I
didn't check.
Now it works for me:
eth1: PHY ID 20005c90 at 1 IRQ 0 (stmmac-1:01) active
PHY: stmmac-1:01 - Link is Up - 100/Full
drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c | 2 +-
1 files changed, 1 insertions(+), 1 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
index 6e712c5..819606e 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
@@ -154,7 +154,7 @@ int stmmac_mdio_register(struct net_device *ndev)
else
irqlist = priv->mii_irq;
- new_bus->name = "STMMAC MII Bus";
+ new_bus->name = "stmmac";
new_bus->read =&stmmac_mdio_read;
new_bus->write =&stmmac_mdio_write;
new_bus->reset =&stmmac_mdio_reset;