Re: [PATCH] Prevent interface errors with Seagate FreeAgent GoFlex

[Martin Mokrejs]

Daniel J Blueman wrote:
> When connected by the optional eSATAp cable, various interface errors
> occur with my new external Seagate FreeAgent GoFlex (firmware 0110) until
> the interface is forced to 1.5Gbps mode. Blacklist 3.0Gbps mode with it
> to avoid the error messages, delays and dataloss potential.
> 
> Signed-off-by: Daniel J Blueman <daniel@xxxxxxxxx>
> ---
>  drivers/ata/libata-core.c |    1 +
>  1 file changed, 1 insertion(+)
> 
> diff --git a/drivers/ata/libata-core.c b/drivers/ata/libata-core.c
> index 28db50b..0781510 100644
> --- a/drivers/ata/libata-core.c
> +++ b/drivers/ata/libata-core.c
> @@ -4119,6 +4119,7 @@ static const struct ata_blacklist_entry ata_device_blacklist [] = {
>  
>  	/* Devices which aren't very happy with higher link speeds */
>  	{ "WD My Book",			NULL,	ATA_HORKAGE_1_5_GBPS, },
> +	{ "Seagate FreeAgent GoFlex",	NULL,	ATA_HORKAGE_1_5_GBPS, },
>  
>  	/*
>  	 * Devices which choke on SETXFER.  Applies only if both the



Hi,
  maybe I am talking nonsense but recently there were some fixes to bus speed posted here at
linux-ide list from Lin Ming <ming.m.lin@xxxxxxxxx>.

In 3.4-rc5 it is already fixed so that if you unplug and re-plug a SATA disk it can be detected
at 3.0Gbps instead of just 1.5 (because previous unplug caused errors). An additional patch
"Subject: [PATCH v2] libata: skip old error history when counting probe trials"
was just applied few hours ago some maybe you want to re-test? So is your blacklisting necessary?

When inspecting my "lspci -vvvxx" outputs I see that lots of my chipset devices in my SandyBridge
laptop lifted up with the above mentioned patch from 2.5Gbps to 5Gbps
(was about in a thread "Re: Hotplug borked after suspend/resume in Linux-3.3 ?") which did not
original tackle the error counter issue which broke the re-plugging.

Probably ask Lin Ming directly as he wrote all the patches, or lookup linux-ide archives.
Hope this helps,
Martin
(I still do see problems with 3.4-rc5 on ExpressCard housed sata_sil24 so that unplug of a disk
and its re-plug results still only in 1.5Gbps instead of 3.0 Gbps, but if one waits a while
so that the SCSI device is removed, then a re-plug catches up at 3 Gbps. Probably have to apply
the patch to null the error counter. ;-))
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/