Re: RTL8101E/RTL8102E PCI Express Fast Ethernet controller (rev 02)

[Francois Romieu]

Thanasis <thanasis@xxxxxxxxxxxxxx> :
[...]
> Ping failed in the following step:
> 
> HEAD is now at 3c6ad46 r8169: move rtl_set_rx_mode before its
> rtl_hw_start callers.

*spleen*

It's a genuine code move without any real change. Imho it's more a
matter of sleeping a few seconds for the link to settle after the
device is brought up.

The differences between the top-most r8169 driver you tried and the
real v3.5.4 r8169 driver are minor : mostly Ben Grear's corrupted
frames rx work (default: disabled) and a skb_timestamp which comes
too late in your setup.

So, either your problem lacks of reproducibility with 3.5.4 - cold reboot,
driver which does not fail the first time - or it needs something else
in the kernel to happen.

The "PME# disabled" messages have disappeared between 2.6 and 3.5.4 in your
dmesg. It's probably due to a dev_dbg/dev_printk + CONFIG_DYNAMIC_DEBUG
change. It's still worth checking runtime pm settings though

Can you check the content of /sys/class/pci_bus/0000:02/power, set it
to "on" if it contains "auto" and plug the cable again (with 3.5.4) ?

-- 
Ueimor
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/