Re: 3.4.4: disabling irq

[Alan Stern]

On Sat, 17 Nov 2012, Udo van den Heuvel wrote:

> The problem still happens. irq 18 is dsiabled every now and then.
> This time on different, new hardware.
> The motherboard is now a Gigabyte F2A85X-UP4.
> Camera is the same pwc cam.
> 
> Recently I removed the USB printer that was attached to the same USB
> controller.
> So probably it is not a hardware issue related to board or printer.
> 
> How to proceed next?

Firstly, what does /proc/interrupts say?

Secondly, try building a kernel with the patch below and 
CONFIG_USB_DEBUG enabled.  Let's see what the dmesg log says when the 
problem occurs.

Alan Stern



Index: usb-3.7/drivers/usb/host/ohci-hcd.c
===================================================================
--- usb-3.7.orig/drivers/usb/host/ohci-hcd.c
+++ usb-3.7/drivers/usb/host/ohci-hcd.c
@@ -777,6 +777,7 @@ static irqreturn_t ohci_irq (struct usb_
 	struct ohci_hcd		*ohci = hcd_to_ohci (hcd);
 	struct ohci_regs __iomem *regs = ohci->regs;
 	int			ints;
+	int			i, j;
 
 	/* Read interrupt status (and flush pending writes).  We ignore the
 	 * optimization of checking the LSB of hcca->done_head; it doesn't
@@ -795,11 +796,15 @@ static irqreturn_t ohci_irq (struct usb_
 	}
 
 	/* We only care about interrupts that are enabled */
-	ints &= ohci_readl(ohci, &regs->intrenable);
+	i = ints;
+	j = ohci_readl(ohci, &regs->intrenable);
+	ints &= j;
 
 	/* interrupt for some other device? */
-	if (ints == 0 || unlikely(ohci->rh_state == OHCI_RH_HALTED))
+	if (ints == 0 || unlikely(ohci->rh_state == OHCI_RH_HALTED)) {
+		ohci_dbg(ohci, "IRQ: %x %x\n", i, j);
 		return IRQ_NOTMINE;
+	}
 
 	if (ints & OHCI_INTR_UE) {
 		// e.g. due to PCI Master/Target Abort

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/