Re: [RFC PATCH 0/6] kvm: Growable memory slot array

[Alex Williamson]

On Tue, 2012-12-04 at 13:48 +0200, Gleb Natapov wrote:
> On Mon, Dec 03, 2012 at 04:39:05PM -0700, Alex Williamson wrote:
> > Memory slots are currently a fixed resource with a relatively small
> > limit.  When using PCI device assignment in a qemu guest it's fairly
> > easy to exhaust the number of available slots.  I posted patches
> > exploring growing the number of memory slots a while ago, but it was
> > prior to caching memory slot array misses and thefore had potentially
> > poor performance.  Now that we do that, Avi seemed receptive to
> > increasing the memory slot array to arbitrary lengths.  I think we
> > still don't want to impose unnecessary kernel memory consumptions on
> > guests not making use of this, so I present again a growable memory
> > slot array.
> > 
> > A couple notes/questions; in the previous version we had a
> > kvm_arch_flush_shadow() call when we increased the number of slots.
> > I'm not sure if this is still necessary.  I had also made the x86
> > specific slot_bitmap dynamically grow as well and switch between a
> > direct bitmap and indirect pointer to a bitmap.  That may have
> > contributed to needing the flush.  I haven't done that yet here
> > because it seems like an unnecessary complication if we have a max
> > on the order of 512 or 1024 entries.  A bit per slot isn't a lot of
> > overhead.  If we want to go more, maybe we should make it switch.
> > That leads to the final question, we need an upper bound since this
> > does allow consumption of extra kernel memory, what should it be?  A
> This is the most important question :) If we want to have 1000s of
> them or 100 is enough?

We can certainly hit respectable numbers of assigned devices in the
hundreds.  Worst case is 8 slots per assigned device, typical case is 4
or less.  So 512 slots would more or less guarantee 64 devices (we do
need some slots for actual memory), and more typically allow at least
128 devices.  Philosophically, supporting a full PCI bus, 256 functions,
2048 slots, is an attractive target, but it's probably no practical.

I think on x86 a slot is 72 bytes w/ alignment padding, so a maximum of
36k @512 slots.

>  Also what about changing kvm_memslots->memslots[]
> array to be "struct kvm_memory_slot *memslots[KVM_MEM_SLOTS_NUM]"? It
> will save us good amount of memory for unused slots.

I'm not following where that results in memory savings.  Can you
clarify.  Thanks,

Alex


--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/