Re: [PATCH 11/12] ARM: ux500: Use the GPIO regulator framework forSDI0's 'en' and 'vsel'

[Ulf Hansson]

On 10 December 2012 11:30, Lee Jones <lee.jones@xxxxxxxxxx> wrote:
>> > +        .constraints = {
>> > +                .min_uV         = 1800000,
>>
>> 2.9V, not 3.3V
>
>> > +static struct gpio_regulator_state sdi0_reg_states[] = {
>> > +        { .value = 3300000, .gpios = (0 << 0) },
>>
>> 2.9V, not 3.3V
>
> I'm still a little unsure about this. I know the actual
> voltage is v2.9, but the supported/requested MMC voltage
> from the driver is v3.3.
>
> Will it still work if I set it all up as v2.9?
>

So that is if course important to consider. Although the regulator
must nu lie about what it actually supports.

In this case mmci driver will have to decide what to do when 3.3V is
requested, but only 2.9 is supported.

> --
> Lee Jones
> Linaro ST-Ericsson Landing Team Lead
> Linaro.org â Open source software for ARM SoCs
> Follow Linaro: Facebook | Twitter | Blog

Kind regards
Ulf Hansson
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/