Re: [PATCH RESEND 0/6 v10] gpio: Add block GPIO

[Russell King - ARM Linux]

On Sat, Dec 15, 2012 at 12:49:57AM +0100, Roland Stigge wrote:
> Without having an AT91 available right now, I guess the hardware
> interface of this GPIO chip is different from the GPIO block API. While
> the hardware has clear and set registers, the val parameter of
> at91_gpiolib_set_block() should be interpreted as the actual output
> values. See lpc32xx_gpo_set_block() for an example for handling set and
> clear registers like this: First, set_bits and clear_bits words are
> calculated from mask and val parameters, and finally written to the
> respective hardware registers.
> 
> Note that one .set_block() can result in writing both the set and clear
> registers of the hardware when val contains both 0s and 1s in
> respectively masked positions.

Note also that if this is the same IP as found in SAM3N devices, that it's
possible to write the bit values directly through the OWER/OWDR (output
write enable register/disable register) plus the ODSR (output data status
register) which will synchronously change the state of all the
write-enabled output pins.  That may be important for some applications.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/