Re: [PATCH] drivers/block/xsysace - replace in(out)_8/in(out)_be16/in(out)_le16with generic iowrite(read)8/16(be)

[Grant Likely]

On Thu, Feb 7, 2013 at 2:39 PM, Grant Likely <grant.likely@xxxxxxxxxxxx> wrote:
> On Wed, Feb 6, 2013 at 9:35 PM, Benjamin Herrenschmidt
> <benh@xxxxxxxxxxxxxxxxxxx> wrote:
>>>  In fact, the driver already knows about this and figures
>>> out at runtime how the device is wired up to the bus. This is not the
>>> problem.
>>
>> Except that this is very gross, especially when you observe that in the
>> busted "big endian" case, it has to byteswap the bloody data port.
>>
>> So you end up having to do that gross hack with separate accessors for
>> registers vs. data and not able to use the _rep variants, which also
>> means that on platforms like ppc, you end up with a memory barrier on
>> every access (or more), which is going to slow things down enormously.
>
> I don't see why the _rep variants aren't usable here. The only reason
> I didn't use them when I wrote the driver in the first place was I was
> a n00b kernel hacker and I didn't know they were there.

The 8-bit variant is different though because the hardware requires
pingponging between odd and even byte addresses to flush the fifo.
Reading a data port even address (0x40) gives the least significant
byte. Reading from an odd address (0x41) give the MSB and pops the
data off the FIFO. So, yes, the _rep variant can't be used in 8-bit
mode. It should still be fine in 16-bit.

page 45: http://www.xilinx.com/support/documentation/data_sheets/ds080.pdf
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/