Re: ahci driver cannot suspend a CF card, ata_piix can

[Aaron Lu]

On 04/16/2013 07:58 PM, Boszormenyi Zoltan wrote:
> Hi,
>
> The SATA interface can be switched between AHCI and legacy modes as usual:
>
> 00:1f.2 SATA controller: Intel Corporation NM10/ICH7 Family SATA
> Controller [AHCI mode] (rev 02)
>
> The device attached to the SATA controller is always a CF card via a
> SiI3811 Serial ATA to Parallel ATA Device Bridge based converter board.

Can you please attach a normal sata disk and try again with the
controller set to AHCI mode? I suspect it may be the SiI3811 bridge that
caused this command.

Thanks,
Aaron

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/