Re: [PATCH 3/6] ASoC: ux500: Drop pinctrl sleep support

[Lee Jones]

On Wed, 08 May 2013, Fabio Baltieri wrote:

> Drop pinctrl default/sleep state switching code, as it was breaking the
> capture interface by putting the I2S pins in hi-z mode regardless of its
> usage status, and not giving any real benefit.
> 
> Pinctrl default mode configuration is already managed automatically by a
> specific pinctrl hog.

I'm sure we should support pinctrl though shouldn't we?

Is there no way of fixing the implementation instead of ripping it out?

> Signed-off-by: Fabio Baltieri <fabio.baltieri@xxxxxxxxxx>
> ---
>  sound/soc/ux500/ux500_msp_i2s.c | 56 ++---------------------------------------
>  sound/soc/ux500/ux500_msp_i2s.h |  6 -----
>  2 files changed, 2 insertions(+), 60 deletions(-)
> 
> diff --git a/sound/soc/ux500/ux500_msp_i2s.c b/sound/soc/ux500/ux500_msp_i2s.c
> index 964cfd6..8512c78 100644
> --- a/sound/soc/ux500/ux500_msp_i2s.c
> +++ b/sound/soc/ux500/ux500_msp_i2s.c
> @@ -15,7 +15,6 @@
>  
>  #include <linux/module.h>
>  #include <linux/platform_device.h>
> -#include <linux/pinctrl/consumer.h>
>  #include <linux/delay.h>
>  #include <linux/slab.h>
>  #include <linux/io.h>
> @@ -28,9 +27,6 @@
>  
>  #include "ux500_msp_i2s.h"
>  
> -/* MSP1/3 Tx/Rx usage protection */
> -static DEFINE_SPINLOCK(msp_rxtx_lock);
> -
>   /* Protocol desciptors */
>  static const struct msp_protdesc prot_descs[] = {
>  	{ /* I2S */
> @@ -358,24 +354,8 @@ static int configure_multichannel(struct ux500_msp *msp,
>  
>  static int enable_msp(struct ux500_msp *msp, struct ux500_msp_config *config)
>  {
> -	int status = 0, retval = 0;
> +	int status = 0;
>  	u32 reg_val_DMACR, reg_val_GCR;
> -	unsigned long flags;
> -
> -	/* Check msp state whether in RUN or CONFIGURED Mode */
> -	if (msp->msp_state == MSP_STATE_IDLE) {
> -		spin_lock_irqsave(&msp_rxtx_lock, flags);
> -		if (msp->pinctrl_rxtx_ref == 0 &&
> -			!(IS_ERR(msp->pinctrl_p) || IS_ERR(msp->pinctrl_def))) {
> -			retval = pinctrl_select_state(msp->pinctrl_p,
> -						msp->pinctrl_def);
> -			if (retval)
> -				pr_err("could not set MSP defstate\n");
> -		}
> -		if (!retval)
> -			msp->pinctrl_rxtx_ref++;
> -		spin_unlock_irqrestore(&msp_rxtx_lock, flags);
> -	}
>  
>  	/* Configure msp with protocol dependent settings */
>  	configure_protocol(msp, config);
> @@ -632,8 +612,7 @@ int ux500_msp_i2s_trigger(struct ux500_msp *msp, int cmd, int direction)
>  
>  int ux500_msp_i2s_close(struct ux500_msp *msp, unsigned int dir)
>  {
> -	int status = 0, retval = 0;
> -	unsigned long flags;
> +	int status = 0;
>  
>  	dev_dbg(msp->dev, "%s: Enter (dir = 0x%01x).\n", __func__, dir);
>  
> @@ -645,18 +624,6 @@ int ux500_msp_i2s_close(struct ux500_msp *msp, unsigned int dir)
>  			       (~(FRAME_GEN_ENABLE | SRG_ENABLE))),
>  			      msp->registers + MSP_GCR);
>  
> -		spin_lock_irqsave(&msp_rxtx_lock, flags);
> -		WARN_ON(!msp->pinctrl_rxtx_ref);
> -		msp->pinctrl_rxtx_ref--;
> -		if (msp->pinctrl_rxtx_ref == 0 &&
> -			!(IS_ERR(msp->pinctrl_p) || IS_ERR(msp->pinctrl_sleep))) {
> -			retval = pinctrl_select_state(msp->pinctrl_p,
> -						msp->pinctrl_sleep);
> -			if (retval)
> -				pr_err("could not set MSP sleepstate\n");
> -		}
> -		spin_unlock_irqrestore(&msp_rxtx_lock, flags);
> -
>  		writel(0, msp->registers + MSP_GCR);
>  		writel(0, msp->registers + MSP_TCF);
>  		writel(0, msp->registers + MSP_RCF);
> @@ -745,25 +712,6 @@ int ux500_msp_i2s_init_msp(struct platform_device *pdev,
>  	dev_dbg(&pdev->dev, "I2S device-name: '%s'\n", i2s_cont->name);
>  	msp->i2s_cont = i2s_cont;
>  
> -	msp->pinctrl_p = pinctrl_get(msp->dev);
> -	if (IS_ERR(msp->pinctrl_p))
> -		dev_err(&pdev->dev, "could not get MSP pinctrl\n");
> -	else {
> -		msp->pinctrl_def = pinctrl_lookup_state(msp->pinctrl_p,
> -						PINCTRL_STATE_DEFAULT);
> -		if (IS_ERR(msp->pinctrl_def)) {
> -			dev_err(&pdev->dev,
> -				"could not get MSP defstate (%li)\n",
> -				PTR_ERR(msp->pinctrl_def));
> -		}
> -		msp->pinctrl_sleep = pinctrl_lookup_state(msp->pinctrl_p,
> -						PINCTRL_STATE_SLEEP);
> -		if (IS_ERR(msp->pinctrl_sleep))
> -			dev_err(&pdev->dev,
> -				"could not get MSP idlestate (%li)\n",
> -				PTR_ERR(msp->pinctrl_def));
> -	}
> -
>  	return 0;
>  }
>  
> diff --git a/sound/soc/ux500/ux500_msp_i2s.h b/sound/soc/ux500/ux500_msp_i2s.h
> index 1311c0d..1ce336f 100644
> --- a/sound/soc/ux500/ux500_msp_i2s.h
> +++ b/sound/soc/ux500/ux500_msp_i2s.h
> @@ -530,12 +530,6 @@ struct ux500_msp {
>  	int loopback_enable;
>  	u32 backup_regs[MAX_MSP_BACKUP_REGS];
>  	unsigned int f_bitclk;
> -	/* Pin modes */
> -	struct pinctrl *pinctrl_p;
> -	struct pinctrl_state *pinctrl_def;
> -	struct pinctrl_state *pinctrl_sleep;
> -	/* Reference Count */
> -	int pinctrl_rxtx_ref;
>  };
>  
>  struct ux500_msp_dma_params {

-- 
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org â Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/