Re: [PATCH 6/6] ASoC: ux500: Use the first two AD slots for capture

[Fabio Baltieri]

On Wed, May 08, 2013 at 11:56:54AM +0100, Mark Brown wrote:
> On Wed, May 08, 2013 at 09:14:21AM +0200, Fabio Baltieri wrote:
> > Set AD_OUT1 and AD_OUT2, corresponding to LINL and LINR pins, as the
> > default input slots for the capture interfaces.
> 
> If these are routing specific analogue inputs to specific timeslots then
> this is routing that should be being exposed to DAPM as muxes, not hard
> coded in the middle of TDM slot configuration (which is both obscure and
> not what the TDM API is there for).  The TDM API should be purely about
> placing the timeslots for the audio interface on the bus.

Ok, it makes sense.  Again, this patch was wrote as a fix to the
existing codebase to make the driver usable with the actual board
available to the community (the snowball).

Fabio

-- 
Fabio Baltieri
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/