Re: [RFC 10/10] irqchip: Make versatile fpga irq driver a generic chip
From: Grant Likely
Date: Mon Jun 10 2013 - 06:33:44 EST
On Mon, Jun 10, 2013 at 10:03 AM, Russell King - ARM Linux
<linux@xxxxxxxxxxxxxxxx> wrote:
> On Mon, Jun 10, 2013 at 01:49:22AM +0100, Grant Likely wrote:
>> This is an RFC patch to convert the versatile FPGA irq controller driver
>> to use generic irq chip. It builds on the series that extends the
>> generic chip code to allow a linear irq domain to contain one or more
>> generic irq chips so that each interrupt controller doesn't need to hand
>> code the generic chip setup.
>
> NAK, this makes functional changes. You assume that the validity mask is
> a set of zeros followed by a set of ones. This is not always the case.
> The PIC on Integrator/CP only has bits 29-22 and 11-0 set because 21-12
> are not valid.
Actually, I don't (at least I don't intend to). It chooses the size of
the irq_domain based on fls(), but that is only because the size has
to allocates for both the holes and the active irqs. You'll notice
that gc->unused is set to ~valid, and the generic chip code will
refuse to map in interrupt that isn't supported. If you see something
different, please point out where because that would be a bug.
g.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/