[PATCH] USB: ehci-omap: Tweak PHY initialization sequence

[Roger Quadros]

For PHY mode, the PHYs must be brought out of reset
before the EHCI controller is started.

This patch fixes the issue where USB devices are not found
on Beagleboard/Beagle-xm if USB has been started previously
by the bootloader. (e.g. by "usb start" command in u-boot)

Tested on Beagleboard, Beagleboard-xm and Pandaboard.

Issue present on 3.10 onwards.

Reported-by: Tomi Valkeinen <tomi.valkeinen@xxxxxx>
Tested-by: Tomi Valkeinen <tomi.valkeinen@xxxxxx>
Signed-off-by: Roger Quadros <rogerq@xxxxxx>
---
 drivers/usb/host/ehci-omap.c |   11 +++++++++--
 1 files changed, 9 insertions(+), 2 deletions(-)

diff --git a/drivers/usb/host/ehci-omap.c b/drivers/usb/host/ehci-omap.c
index 16d7150..dda408f 100644
--- a/drivers/usb/host/ehci-omap.c
+++ b/drivers/usb/host/ehci-omap.c
@@ -187,6 +187,12 @@ static int ehci_hcd_omap_probe(struct platform_device *pdev)
 		}
 
 		omap->phy[i] = phy;
+
+		if (pdata->port_mode[i] == OMAP_EHCI_PORT_MODE_PHY) {
+			usb_phy_init(omap->phy[i]);
+			/* bring PHY out of suspend */
+			usb_phy_set_suspend(omap->phy[i], 0);
+		}
 	}
 
 	pm_runtime_enable(dev);
@@ -211,13 +217,14 @@ static int ehci_hcd_omap_probe(struct platform_device *pdev)
 	}
 
 	/*
-	 * Bring PHYs out of reset.
+	 * Bring PHYs out of reset for non PHY modes.
 	 * Even though HSIC mode is a PHY-less mode, the reset
 	 * line exists between the chips and can be modelled
 	 * as a PHY device for reset control.
 	 */
 	for (i = 0; i < omap->nports; i++) {
-		if (!omap->phy[i])
+		if (!omap->phy[i] ||
+		     pdata->port_mode[i] == OMAP_EHCI_PORT_MODE_PHY)
 			continue;
 
 		usb_phy_init(omap->phy[i]);
-- 
1.7.4.1

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/