Re: [PATCH v3 1/4] pinctrl-tz1090: add TZ1090 pinctrl driver

[Linus Walleij]

On Thu, Jun 20, 2013 at 11:26 AM, James Hogan <james.hogan@xxxxxxxxxx> wrote:

> Add a pin control driver for the main pins on the TZ1090 SoC. This
> doesn't include the low-power pins as they're controlled separately via
> the Powerdown Controller (PDC) registers.
>
> Signed-off-by: James Hogan <james.hogan@xxxxxxxxxx>
> Cc: Grant Likely <grant.likely@xxxxxxxxxx>
> Cc: Rob Herring <rob.herring@xxxxxxxxxxx>
> Cc: Rob Landley <rob@xxxxxxxxxxx>
> Cc: Linus Walleij <linus.walleij@xxxxxxxxxx>
> Cc: linux-doc@xxxxxxxxxxxxxxx
> Cc: devicetree-discuss@xxxxxxxxxxxxxxxx
> ---
> Changes in v3:
>  - separated from irq-imgpdc and removed arch/metag changes to allow
>    these patches to go upstream separately via the pinctrl[/gpio] trees
>    (particularly the pinctrl drivers depend on the new pinconf DT
>    bindings).
>  - some s/unsigned/unsigned int/.
>  - some s/unsigned int/bool/ and use of BIT().
>  - pinctrl-tz1090*: switch to generic pinconfig DT bindings and
>    pinconf_generic_dump_config.
>  - pinctrl-tz1090*: use tz1090, prefix for pins and function in DT
>    bindings.
>  - pinctrl-tz1090*: make internal functions static.
>  - pinctrl-tz1090*: move initcall from postcore to arch.

Thanks James, patch applied.

Also thanks for helping out in getting the generic pinconf
in place for some three different drivers for this merge window,
this was very good for pinctrl at large.

Yours,
Linus Walleij
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/