Re: [PATCH 1/3] misc: Add crossbar driver

[Sricharan R]

On Friday 19 July 2013 12:47 PM, Tony Lindgren wrote:
>> On Thursday 18 July 2013 02:56 PM, Nishanth Menon wrote:
>>
>> Since the cross-bar is not limited t0 IRQ lines and applicable for
>> DMA request lines as well, making it IRQ chip doesn't make sense. Its
>> not typical pin control functionality either but at least that framework
>> is much closer to consider as an option.
>>
>> Actually its more of setting up the IRQ and DMA pins maps once
>> at boot for a given SOC based on chosen configuration by the
>> board. So I am leaning towards pinctrl as well. Just haven't
>> thought enough about whether thats the best approach.
>>
>> CC'ing Linus W and Tony L whether we can use pinctrl framework
>> for such an IP and if yes how ;-).
> If it really muxes signals then using pinctrl seems logical.
> Especially if the registers are in the SCM block.
>
> It might be already possible to handle it already with
> pinctrl-single,bits for the muxing part.
 I also thought of using the pinctrl itself.
 But then i wanted  to have the error handling as well,
 hence did this.

Regards,
 Sricharan
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/