[PATCH RFC 1/5] media: s5p-tv: Fix sdo driver to work with CCF

[Mateusz Krawczuk]

Replace clk_enable by clock_enable_prepare and clk_disable with clk_disable_unprepare.
Clock prepare is required by Clock Common Framework, and old clock driver didn`t support it.
Without it Common Clock Framework prints a warning.

Signed-off-by: Mateusz Krawczuk <m.krawczuk@xxxxxxxxxxxxxxxxxxx>
---
 drivers/media/platform/s5p-tv/sdo_drv.c | 44 +++++++++++++++++++++++++--------
 1 file changed, 34 insertions(+), 10 deletions(-)

diff --git a/drivers/media/platform/s5p-tv/sdo_drv.c b/drivers/media/platform/s5p-tv/sdo_drv.c
index 0afa90f..77eac6d 100644
--- a/drivers/media/platform/s5p-tv/sdo_drv.c
+++ b/drivers/media/platform/s5p-tv/sdo_drv.c
@@ -55,6 +55,8 @@ struct sdo_device {
 	struct clk *dacphy;
 	/** clock for control of VPLL */
 	struct clk *fout_vpll;
+	/** vpll rate before sdo stream was on */
+	int vpll_rate;
 	/** regulator for SDO IP power */
 	struct regulator *vdac;
 	/** regulator for SDO plug detection */
@@ -193,17 +195,34 @@ static int sdo_s_power(struct v4l2_subdev *sd, int on)
 
 static int sdo_streamon(struct sdo_device *sdev)
 {
+	int ret = 0;
+
 	/* set proper clock for Timing Generator */
-	clk_set_rate(sdev->fout_vpll, 54000000);
+	sdev->vpll_rate = clk_get_rate(sdev->fout_vpll);
+	ret = clk_set_rate(sdev->fout_vpll, 54000000);
+	if (ret < 0) {
+		dev_err(sdev->dev,
+			"%s: Failed to set vpll rate!\n", __func__);
+		return ret;
+	}
 	dev_info(sdev->dev, "fout_vpll.rate = %lu\n",
 	clk_get_rate(sdev->fout_vpll));
 	/* enable clock in SDO */
 	sdo_write_mask(sdev, SDO_CLKCON, ~0, SDO_TVOUT_CLOCK_ON);
-	clk_enable(sdev->dacphy);
+	ret = clk_prepare_enable(sdev->dacphy);
+	if (ret < 0) {
+		dev_err(sdev->dev,
+			"%s: Failed to prepare and enable clock !\n", __func__);
+		goto fail;
+	}
 	/* enable DAC */
 	sdo_write_mask(sdev, SDO_DAC, ~0, SDO_POWER_ON_DAC);
 	sdo_reg_debug(sdev);
 	return 0;
+fail:
+	sdo_write_mask(sdev, SDO_CLKCON, 0, SDO_TVOUT_CLOCK_ON);
+	clk_set_rate(sdev->fout_vpll, sdev->vpll_rate);
+	return ret;
 }
 
 static int sdo_streamoff(struct sdo_device *sdev)
@@ -211,7 +230,7 @@ static int sdo_streamoff(struct sdo_device *sdev)
 	int tries;
 
 	sdo_write_mask(sdev, SDO_DAC, 0, SDO_POWER_ON_DAC);
-	clk_disable(sdev->dacphy);
+	clk_disable_unprepare(sdev->dacphy);
 	sdo_write_mask(sdev, SDO_CLKCON, 0, SDO_TVOUT_CLOCK_ON);
 	for (tries = 100; tries; --tries) {
 		if (sdo_read(sdev, SDO_CLKCON) & SDO_TVOUT_CLOCK_READY)
@@ -220,6 +239,7 @@ static int sdo_streamoff(struct sdo_device *sdev)
 	}
 	if (tries == 0)
 		dev_err(sdev->dev, "failed to stop streaming\n");
+	clk_set_rate(sdev->fout_vpll, sdev->vpll_rate);
 	return tries ? 0 : -EIO;
 }
 
@@ -254,7 +274,7 @@ static int sdo_runtime_suspend(struct device *dev)
 	dev_info(dev, "suspend\n");
 	regulator_disable(sdev->vdet);
 	regulator_disable(sdev->vdac);
-	clk_disable(sdev->sclk_dac);
+	clk_disable_unprepare(sdev->sclk_dac);
 	return 0;
 }
 
@@ -266,7 +286,7 @@ static int sdo_runtime_resume(struct device *dev)
 
 	dev_info(dev, "resume\n");
 
-	ret = clk_enable(sdev->sclk_dac);
+	ret = clk_prepare_enable(sdev->sclk_dac);
 	if (ret < 0)
 		return ret;
 
@@ -299,7 +319,7 @@ static int sdo_runtime_resume(struct device *dev)
 vdac_r_dis:
 	regulator_disable(sdev->vdac);
 dac_clk_dis:
-	clk_disable(sdev->sclk_dac);
+	clk_disable_unprepare(sdev->sclk_dac);
 	return ret;
 }
 
@@ -403,10 +423,14 @@ static int sdo_probe(struct platform_device *pdev)
 		ret = PTR_ERR(sdev->vdet);
 		goto fail_fout_vpll;
 	}
-
 	/* enable gate for dac clock, because mixer uses it */
-	clk_enable(sdev->dac);
-
+	clk_prepare_enable(sdev->dac);
+	if (IS_ERR(sdev->dac)) {
+		dev_err(dev,
+			"%s: Failed to prepare and enable clock !\n", __func__);
+		ret = PTR_ERR(sdev->dac);
+		goto fail_fout_vpll;
+	}
 	/* configure power management */
 	pm_runtime_enable(dev);
 
@@ -444,7 +468,7 @@ static int sdo_remove(struct platform_device *pdev)
 	struct sdo_device *sdev = sd_to_sdev(sd);
 
 	pm_runtime_disable(&pdev->dev);
-	clk_disable(sdev->dac);
+	clk_disable_unprepare(sdev->dac);
 	clk_put(sdev->fout_vpll);
 	clk_put(sdev->dacphy);
 	clk_put(sdev->dac);
-- 
1.8.1.2

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/