Re: [PATCH v2 3/6] host1x: hdmi: Enable Vdd earlier for hotplug/DDC

[Mikko Perttunen]

On 09/04/2013 09:44 PM, Stephen Warren wrote:
> On 08/28/2013 09:48 AM, Mikko Perttunen wrote:
> > The Vdd regulator used to be enabled only at tegra_output_hdmi_enable,
> > which is called after a sink is detected. However, the HDMI hotplug pin
> > works by returning the voltage supplied by the Vdd pin, so this meant
> > that the hotplug pin was never asserted and the sink was not detected
> > unless the Vdd regulator was set to be always on.
> >
> > This patch moves the enable to the tegra_hdmi_drm_init function to make
> > sure the regulator will get enabled.
>
> The DT binding document isn't very clear on this topic (and should be
> fixed): What is this regulator intended to control? If this regulator
> solely controls the supply to the hotplug detection circuit, this change
> makes sense. If the regulator mainly supplies something else (e.g. part
> of the HDMI core on the Tegra chip), then perhaps this change isn't
> correct. The correct approach might be to introduce another (optional)
> regulator specifically for the hotplug circuit. Presumably both DT
> properties vdd-supply and hotplug-supply could point at the same
> regulator if that's the way the HW was wired up.
> --
> To unsubscribe from this list: send the line "unsubscribe linux-tegra" in
> the body of a message to majordomo@xxxxxxxxxxxxxxx
> More majordomo info at  http://vger.kernel.org/majordomo-info.html

AFAICT, it controls the Vdd pin on the HDMI port, so it just affects the 
hotplug pin and the DDC I2C bus power.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/