[PATCH] thermal: ti-soc-thermal: clk_round_rate() can return a zeroupon error

[Paul Walmsley]

Treat both negative and zero return values from clk_round_rate() as
errors.  This is needed since subsequent patches will convert
clk_round_rate()'s return value to be an unsigned type, rather than a
signed type, since some clock sources can generate rates higher than
(2^31)-1 Hz.

Eventually, when calling clk_round_rate(), only a return value of zero
will be considered a error.  All other values will be considered valid
rates.  The comparison against values less than 0 is kept to preserve
the correct behavior in the meantime.

This patch also gets rid of a comparison between unsigned and signed 
values; a side-benefit.

Signed-off-by: Paul Walmsley <pwalmsley@xxxxxxxxxx>
Cc: Eduardo Valentin <eduardo.valentin@xxxxxx>
Cc: Zhang Rui <rui.zhang@xxxxxxxxx>
---
Applies on v3.13-rc3.  See also:

http://marc.info/?l=linux-arm-kernel&m=138542591313620&w=2

 drivers/thermal/ti-soc-thermal/ti-bandgap.c |    2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/thermal/ti-soc-thermal/ti-bandgap.c b/drivers/thermal/ti-soc-thermal/ti-bandgap.c
index 74c0e3474d6e..8fe46dbc0c6f 100644
--- a/drivers/thermal/ti-soc-thermal/ti-bandgap.c
+++ b/drivers/thermal/ti-soc-thermal/ti-bandgap.c
@@ -1248,7 +1248,7 @@ int ti_bandgap_probe(struct platform_device *pdev)
 	clk_rate = clk_round_rate(bgp->div_clk,
 				  bgp->conf->sensors[0].ts_data->max_freq);
 	if (clk_rate < bgp->conf->sensors[0].ts_data->min_freq ||
-	    clk_rate == 0xffffffff) {
+	    clk_rate <= 0) {
 		ret = -ENODEV;
 		dev_err(&pdev->dev, "wrong clock rate (%d)\n", clk_rate);
 		goto put_clks;
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/