Re: questions of cpuidle

[Alex Shi]

On 12/10/2013 03:27 PM, Daniel Lezcano wrote:
> 
>> And does the wake up pass via GIC to CPU? If so, does the GIC need
>> keep awake when all cpu idle? If not, how the firmware give the
>> interrupt to CPU? And I am wondering if the deep idle cpu voltage get
>> to near 0. How the cpu get the interrupt signal?
> 
> If a deep idle state powers down the GIC, it is up to the PMU to proxy
> the interrupts. When an interrupt occurs, the PMU powers up the logic,
> including the GIC. The notifier call chain with cpu_suspend / cpu_resume
> will save and restore the GIC registers.
> 
> But this is hardware specific and will depend on how the PMU is
> implemented and how far it goes in the power management.
> 
> You have a good example in the drivers/cpuidle/cpuidle-ux500.c to
> understand with the comments how the interrupts are handled through the
> power management unit.
> 
> In the Xillinx documentation available on the web [1], the chapter 24.4
> gives the information about one kind of PMU.
> 
> I believe the mechanism is pretty similar on all the hardware but it is
> obfuscated by a generic power instruction like mwait.
> 
>   -- Daniel
> 
> [1]
> http://www.xilinx.com/support/documentation/user_guides/ug585-Zynq-7000-TRM.pdf
> 

Thanks a lot, Daniel. You are a expert of ARM cpu idle! :)

-- 
Thanks
    Alex
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/