Re: [lm-sensors] [PATCH V1] fix adc to voltage calculation in da9052power driver

[Guenter Roeck]

On Thu, Dec 19, 2013 at 03:54:54PM +0100, Jean Delvare wrote:
> Hi Anthony,
> 
[ ... ]
> 
> BTW, you (and we) probably shouldn't waste too much energy on this.
> ADCs are only accurate to some degree anyway. If you take the
> components connected to the input into consideration, the accuracy gets
> even worse. For example, if the input voltage must be scaled down to
> fit in the ADC's range, you need at least one resistor, which in best
> cases will have a 1% accurate value (known as tolerance.) That's ten
> times the LSB of your 10-bit ADC, at which point / 1023 or / 1024
> really makes no practical difference. Sub-percent tolerant resistors are
> expensive and rare in consumer electronics in my experience.
> 
True, but on the other side (and after looking into the datasheet)
the driver already calculated the voltage on adc4..6 correctly,
so unless you disagree I would like to apply the hwmon patch to -next
for consistency.

Thanks,
Guenter
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/