[RFC] regulator: anatop-regulator: Also provide a delay when voltage decreases

[Fabio Estevam]

From: Fabio Estevam <fabio.estevam@xxxxxxxxxxxxx>

Currently we only wait for a delay for the LDO voltages to settle when it goes
from a lower voltage to a higher one.

Also provide the delay when the opposite transition happens.

Signed-off-by: Fabio Estevam <fabio.estevam@xxxxxxxxxxxxx>
---
Hi Anson/Shawn,

I could not find in the reference manual anywhere that says that the delay
should de done only when the voltage increases.


 drivers/regulator/anatop-regulator.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/regulator/anatop-regulator.c b/drivers/regulator/anatop-regulator.c
index 7d7c05e..843c5d1 100644
--- a/drivers/regulator/anatop-regulator.c
+++ b/drivers/regulator/anatop-regulator.c
@@ -70,7 +70,7 @@ static int anatop_regmap_set_voltage_time_sel(struct regulator_dev *reg,
 	int ret = 0;
 
 	/* check whether need to care about LDO ramp up speed */
-	if (anatop_reg->delay_bit_width && new_sel > old_sel) {
+	if (anatop_reg->delay_bit_width) {
 		/*
 		 * the delay for LDO ramp up time is
 		 * based on the register setting, we need
@@ -80,7 +80,7 @@ static int anatop_regmap_set_voltage_time_sel(struct regulator_dev *reg,
 		regmap_read(anatop_reg->anatop, anatop_reg->delay_reg, &val);
 		val = (val >> anatop_reg->delay_bit_shift) &
 			((1 << anatop_reg->delay_bit_width) - 1);
-		ret = (new_sel - old_sel) * (LDO_RAMP_UP_UNIT_IN_CYCLES <<
+		ret = abs(new_sel - old_sel) * (LDO_RAMP_UP_UNIT_IN_CYCLES <<
 			val) / LDO_RAMP_UP_FREQ_IN_MHZ + 1;
 	}
 
-- 
1.8.1.2

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/