[PATCH 5/6] at91: dt: sam9261: Add an entry in the DT for the SMC/EBI bus driver.

[jjhiblot]

From: jean-jacques hiblot <jean-jacques.hiblot@xxxxxxxx>

This patch creates a new entry in the device tree for the 9261 under which
should be the devices attached to the EBI.
It also moves the NAND DT entries under this new bus.

Signed-off-by: Jean-Jacques Hiblot <jjhiblot@xxxxxxxxxxxxxxx>
---
 arch/arm/boot/dts/at91sam9261.dtsi  | 32 +++++++++++++++++---------
 arch/arm/boot/dts/at91sam9261ek.dts | 46 ++++++++++++++++++++++++++++---------
 2 files changed, 56 insertions(+), 22 deletions(-)

diff --git a/arch/arm/boot/dts/at91sam9261.dtsi b/arch/arm/boot/dts/at91sam9261.dtsi
index 925f9ad..acd19b4 100644
--- a/arch/arm/boot/dts/at91sam9261.dtsi
+++ b/arch/arm/boot/dts/at91sam9261.dtsi
@@ -525,21 +525,31 @@
 			status = "disabled";
 		};
 
-		nand0: nand@40000000 {
-			compatible = "atmel,at91rm9200-nand";
+		smc: smc@ffffec00 {
 			#address-cells = <1>;
 			#size-cells = <1>;
-			reg = <0x40000000 0x10000000>;
-			atmel,nand-addr-offset = <22>;
-			atmel,nand-cmd-offset = <21>;
+			compatible = "atmel,at91sam9261-smc";
+			reg = <0xffffec00 0x80>;
 			pinctrl-names = "default";
-			pinctrl-0 = <&pinctrl_nand>;
-
-			gpios = <&pioC 15 GPIO_ACTIVE_HIGH
-				&pioC 14 GPIO_ACTIVE_HIGH
-				0
-				>;
 			status = "disabled";
+			ranges = < >;
+			nand0: nand@40000000 {
+				compatible = "atmel,at91rm9200-nand";
+				#address-cells = <1>;
+				#size-cells = <1>;
+				reg = <0x40000000 0x10000000>;
+				atmel,nand-addr-offset = <22>;
+				atmel,nand-cmd-offset = <21>;
+				pinctrl-names = "default";
+				pinctrl-0 = <&pinctrl_nand>, <&pinctrl_smc_nandoe>, <&pinctrl_smc_nandwe>;
+				smc,cs = <3>;
+
+				gpios = <&pioC 15 GPIO_ACTIVE_HIGH
+					&pioC 14 GPIO_ACTIVE_HIGH
+					0
+					>;
+				status = "disabled";
+			};
 		};
 
 		usb0: ohci@00500000 {
diff --git a/arch/arm/boot/dts/at91sam9261ek.dts b/arch/arm/boot/dts/at91sam9261ek.dts
index 03c05fc..11cf619 100644
--- a/arch/arm/boot/dts/at91sam9261ek.dts
+++ b/arch/arm/boot/dts/at91sam9261ek.dts
@@ -42,17 +42,6 @@
 			};
 		};
 
-		nand0: nand@40000000 {
-			nand-bus-width = <8>;
-			nand-ecc-mode = "soft";
-			nand-on-flash-bbt = <1>;
-			status = "okay";
-			at91bootstrap@0 {
-				label = "at91bootstrap";
-				reg = <0x0 0x20000>;
-			};
-		};
-
 		fb0: fb@0x00600000 {
 			display = <&display0>;
 			status = "okay";
@@ -83,6 +72,41 @@
 				};
 			};
 		};
+
+		smc: smc@ffffec00 {
+			status = "okay";
+
+			nand0: nand@40000000 {
+				nand-bus-width = <8>;
+				nand-ecc-mode = "soft";
+				nand-on-flash-bbt = <1>;
+				status = "okay";
+
+				smc,ncs_read_setup = <0>;
+				smc,nrd_setup = <1>;
+				smc,ncs_write_setup = <0>;
+				smc,nwe_setup = <1>;
+				smc,ncs_read_pulse = <3>;
+				smc,nrd_pulse = <3>;
+				smc,ncs_write_pulse = <3>;
+				smc,nwe_pulse = <3>;
+				smc,read_cycle = <5>;
+				smc,write_cycle = <5>;
+				smc,tdf_cycles = <2>;
+				smc,tdf_optimized = <0>;
+				smc,page_size = <0>;
+				smc,byte_access_type = <0>;
+				smc,bus_width = <0>;
+				smc,nwait_mode = <0>;
+				smc,read_mode = <1>;
+				smc,write_mode = <1>;
+
+				at91bootstrap@0 {
+					label = "at91bootstrap";
+					reg = <0x0 0x20000>;
+				};
+			};
+		};
 	};
 
 	leds {
-- 
1.8.4.2

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/