Re: [lm-sensors] Tachometer speed returned rather than absolute fan speed?

[Guenter Roeck]

On 03/07/2014 10:17 AM, Guenter Roeck wrote:
> On Fri, Mar 07, 2014 at 03:47:08PM +0000, Laszlo Papp wrote:
> > On Fri, Mar 7, 2014 at 3:37 PM, Jean Delvare <jdelvare@xxxxxxx> wrote:
> > > > > I'm quite confused. While I admit that the term "tachometer speed" is
> > > > > awkward, the max6650 driver is reporting fan speeds in RPM as every
> > > > > other hwmon driver. So I really have no idea what you think is wrong.
> > > > > What did you think "tachometer speed" was, if not the fan speed? Does
> > > > > the max6650 driver not return correct fan speeds for you?
> >
> > That is some strange behavior. If I do "echo 1 > pwm1_enable; echo 0 >
> > pwm1; cat fan1_input", I still see 30 for the connected fan, whereas I
> > can see it stopped. Is this an expected behavior? I would expect zero
> > as a user.
> I seem to recall that I had seen that as well, with no fan connected.
> Maybe the tachometer registers always read at least '1'. I would think
> it is wrong, but we'll have to understand the chip a bit better
> to be able to provide a fix. Unless you already have a fix ready,
> of course. I'll try to re-test tonight if I find the time.

The reason is (most likely) that your fan input does not have a pull-up
resistor. Per datasheet, the fan inputs need a 10kOhm pull-up resistor.
I confirmed this with my test board - with the pull-up resistor,
inputs read 0, Without pull-up, the reported value is 1, which
translates to 30 RPM.

You might also need the 10 uF capacitor on the FB pin.

Guenter

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/