[PATCHv4 3/4] Documentation: dt: Document TSC2005 DT binding
From: Sebastian Reichel
Date: Wed May 21 2014 - 13:37:21 EST
Add devicetree binding documentation for TSC2005 touchscreen.
Reviewed-by: Pavel Machek <pavel@xxxxxx>
Acked-by: Aaro Koskinen <aaro.koskinen@xxxxxx>
Signed-off-by: Sebastian Reichel <sre@xxxxxxxxxx>
---
.../bindings/input/touchscreen/tsc2005.txt | 42 ++++++++++++++++++++++
1 file changed, 42 insertions(+)
create mode 100644 Documentation/devicetree/bindings/input/touchscreen/tsc2005.txt
diff --git a/Documentation/devicetree/bindings/input/touchscreen/tsc2005.txt b/Documentation/devicetree/bindings/input/touchscreen/tsc2005.txt
new file mode 100644
index 0000000..4b641c7
--- /dev/null
+++ b/Documentation/devicetree/bindings/input/touchscreen/tsc2005.txt
@@ -0,0 +1,42 @@
+* Texas Instruments tsc2005 touchscreen controller
+
+Required properties:
+ - compatible : "ti,tsc2005"
+ - reg : SPI device address
+ - spi-max-frequency : Maximal SPI speed
+ - interrupts : IRQ specifier
+ - reset-gpios : GPIO specifier
+ - vio-supply : Regulator specifier
+
+Optional properties:
+ - ti,x-plate-ohms : integer, resistance of the touchscreen's X plates
+ in ohm (defaults to 280)
+ - ti,esd-recovery-timeout-ms : integer, if the touchscreen does not respond after
+ the configured time (in milli seconds), the driver
+ will reset it. This is disabled by default.
+ - properties defined in touchscreen.txt
+
+Example:
+
+&mcspi1 {
+ tsc2005@0 {
+ compatible = "ti,tsc2005";
+ spi-max-frequency = <6000000>;
+ reg = <0>;
+
+ vio-supply = <&vio>;
+
+ reset-gpios = <&gpio4 8 GPIO_ACTIVE_HIGH>; /* 104 */
+ interrupts-extended = <&gpio4 4 IRQ_TYPE_EDGE_RISING>; /* 100 */
+
+ touchscreen-fuzz-x = <4>;
+ touchscreen-fuzz-y = <7>;
+ touchscreen-fuzz-pressure = <2>;
+ touchscreen-max-x = <4096>;
+ touchscreen-max-y = <4096>;
+ touchscreen-max-pressure = <2048>;
+
+ ti,x-plate-ohms = <280>;
+ ti,esd-recovery-timeout-ms = <8000>;
+ };
+}
--
2.0.0.rc2
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/