Re: [PATCH] drivers/char/mem.c: Add /dev/ioports, supporting 16-bit and 32-bit ports
From: Maciej W. Rozycki
Date: Sun Jun 01 2014 - 06:35:26 EST
On Sun, 11 May 2014, Josh Triplett wrote:
> > > > What if I attempt a four-byte read at 65535? That would access four
> > > > out-of-bounds bytes, right?
> > >
> > > No, it would do an ind instruction on port 65535.
> >
> > Yes, on x86. What about other architectures?
>
> That's a good point; on architectures that map I/O to memory, this
> device should check port+count rather than port. Is there a reliable
> #define that identifies architectures with that property, other than
> CONFIG_X86?
FWIW, on x86 an IND from 65535 will be split into two separate bus read
cycles, e.g. on a 32-bit data bus one at 0xfffc with only the MSB enabled
and another one with the three LSB enabled (64-bit buses will address the
first cycle at 0xfff8, etc.). Data obtained from these cycles is then
merged appropriately before writing to the destination. The address put
on the bus for the second cycle is implementation-specific as are all
accesses beyond 0xffff so it might be 0x10000 or it might be 0.
If implementing unaligned port I/O on non-x86 targets I think it would be
most reasonable to wrap the out-of-range part around back to 0 before
merging data obtained this way. The range supported can of course be
different to what x86 supports and may be specific e.g. to the PCI host
bridge (its port I/O space forwarding window size). Systems with peer
bridges may have multiple port I/O spaces too, this is one reason to have
the size of the port I/O space extended beyond 64kB; address bits from #16
up can then be used to select the intended host bridge to forward the
access to. Also IIRC PCI-PCI bridges only forward port I/O space accesses
within the low 64kB.
Most easily unaligned port I/O may not be supported at all by our kernel
device, even on x86. I think it would actually be reasonable to do, I
have yet to hear of a piece of hardware that has any use for unaligned
port I/O.
Maciej
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/