[PATCH 02/11] tlan: Enable link monitoring
From: Ondrej Zary
Date: Sat Jun 21 2014 - 10:49:06 EST
Enable old link monitoring code and modify it:
- control LINK LED
- use separate timer so it does not interfere with ACT LED
Tested with Olicom OC-2326.
Signed-off-by: Ondrej Zary <linux@xxxxxxxxxxxxxxxxxxxx>
---
drivers/net/ethernet/ti/tlan.c | 115 +++++++++++++++++-----------------------
drivers/net/ethernet/ti/tlan.h | 3 +-
2 files changed, 49 insertions(+), 69 deletions(-)
diff --git a/drivers/net/ethernet/ti/tlan.c b/drivers/net/ethernet/ti/tlan.c
index e7449cb..c75ad6b 100644
--- a/drivers/net/ethernet/ti/tlan.c
+++ b/drivers/net/ethernet/ti/tlan.c
@@ -69,10 +69,6 @@ MODULE_AUTHOR("Maintainer: Samuel Chessman <chessman@xxxxxxx>");
MODULE_DESCRIPTION("Driver for TI ThunderLAN based ethernet PCI adapters");
MODULE_LICENSE("GPL");
-
-/* Define this to enable Link beat monitoring */
-#undef MONITOR
-
/* Turn on debugging. See Documentation/networking/tlan.txt for details */
static int debug;
module_param(debug, int, 0);
@@ -194,9 +190,7 @@ static void tlan_phy_power_up(struct net_device *);
static void tlan_phy_reset(struct net_device *);
static void tlan_phy_start_link(struct net_device *);
static void tlan_phy_finish_auto_neg(struct net_device *);
-#ifdef MONITOR
-static void tlan_phy_monitor(struct net_device *);
-#endif
+static void tlan_phy_monitor(unsigned long);
/*
static int tlan_phy_nop(struct net_device *);
@@ -340,6 +334,7 @@ static void tlan_stop(struct net_device *dev)
{
struct tlan_priv *priv = netdev_priv(dev);
+ del_timer_sync(&priv->media_timer);
tlan_read_and_clear_stats(dev, TLAN_RECORD);
outl(TLAN_HC_AD_RST, dev->base_addr + TLAN_HOST_CMD);
/* Reset and power down phy */
@@ -889,6 +884,7 @@ static int tlan_open(struct net_device *dev)
}
init_timer(&priv->timer);
+ init_timer(&priv->media_timer);
tlan_start(dev);
@@ -1811,11 +1807,6 @@ static void tlan_timer(unsigned long data)
priv->timer.function = NULL;
switch (priv->timer_type) {
-#ifdef MONITOR
- case TLAN_TIMER_LINK_BEAT:
- tlan_phy_monitor(dev);
- break;
-#endif
case TLAN_TIMER_PHY_PDOWN:
tlan_phy_power_down(dev);
break;
@@ -1859,8 +1850,6 @@ static void tlan_timer(unsigned long data)
}
-
-
/*****************************************************************************
******************************************************************************
@@ -2258,42 +2247,39 @@ tlan_finish_reset(struct net_device *dev)
tlan_mii_read_reg(dev, phy, MII_GEN_STS, &status);
udelay(1000);
tlan_mii_read_reg(dev, phy, MII_GEN_STS, &status);
- if ((status & MII_GS_LINK) &&
- /* We only support link info on Nat.Sem. PHY's */
- (tlphy_id1 == NAT_SEM_ID1) &&
- (tlphy_id2 == NAT_SEM_ID2)) {
- tlan_mii_read_reg(dev, phy, MII_AN_LPA, &partner);
- tlan_mii_read_reg(dev, phy, TLAN_TLPHY_PAR, &tlphy_par);
-
- netdev_info(dev,
- "Link active with %s %uMbps %s-Duplex\n",
- !(tlphy_par & TLAN_PHY_AN_EN_STAT)
- ? "forced" : "Autonegotiation enabled,",
- tlphy_par & TLAN_PHY_SPEED_100
- ? 100 : 10,
- tlphy_par & TLAN_PHY_DUPLEX_FULL
- ? "Full" : "Half");
-
- if (tlphy_par & TLAN_PHY_AN_EN_STAT) {
- netdev_info(dev, "Partner capability:");
- for (i = 5; i < 10; i++)
- if (partner & (1 << i))
- pr_cont(" %s", media[i-5]);
- pr_cont("\n");
- }
-
- tlan_dio_write8(dev->base_addr, TLAN_LED_REG,
- TLAN_LED_LINK);
-#ifdef MONITOR
- /* We have link beat..for now anyway */
- priv->link = 1;
- /*Enabling link beat monitoring */
- tlan_set_timer(dev, (10*HZ), TLAN_TIMER_LINK_BEAT);
-#endif
- } else if (status & MII_GS_LINK) {
- netdev_info(dev, "Link active\n");
- tlan_dio_write8(dev->base_addr, TLAN_LED_REG,
- TLAN_LED_LINK);
+ if (status & MII_GS_LINK) {
+ /* We only support link info on Nat.Sem. PHY's */
+ if ((tlphy_id1 == NAT_SEM_ID1) &&
+ (tlphy_id2 == NAT_SEM_ID2)) {
+ tlan_mii_read_reg(dev, phy, MII_AN_LPA,
+ &partner);
+ tlan_mii_read_reg(dev, phy, TLAN_TLPHY_PAR,
+ &tlphy_par);
+
+ netdev_info(dev,
+ "Link active, %s %uMbps %s-Duplex\n",
+ !(tlphy_par & TLAN_PHY_AN_EN_STAT)
+ ? "forced" : "Autonegotiation enabled,",
+ tlphy_par & TLAN_PHY_SPEED_100
+ ? 100 : 10,
+ tlphy_par & TLAN_PHY_DUPLEX_FULL
+ ? "Full" : "Half");
+
+ if (tlphy_par & TLAN_PHY_AN_EN_STAT) {
+ netdev_info(dev, "Partner capability:");
+ for (i = 5; i < 10; i++)
+ if (partner & (1 << i))
+ pr_cont(" %s",
+ media[i-5]);
+ pr_cont("\n");
+ }
+ } else
+ netdev_info(dev, "Link active\n");
+ /* Enabling link beat monitoring */
+ priv->media_timer.function = tlan_phy_monitor;
+ priv->media_timer.data = (unsigned long) dev;
+ priv->media_timer.expires = jiffies + HZ;
+ add_timer(&priv->media_timer);
}
}
@@ -2315,6 +2301,7 @@ tlan_finish_reset(struct net_device *dev)
dev->base_addr + TLAN_HOST_CMD + 1);
outl(priv->rx_list_dma, dev->base_addr + TLAN_CH_PARM);
outl(TLAN_HC_GO | TLAN_HC_RT, dev->base_addr + TLAN_HOST_CMD);
+ tlan_dio_write8(dev->base_addr, TLAN_LED_REG, TLAN_LED_LINK);
netif_carrier_on(dev);
} else {
netdev_info(dev, "Link inactive, will retry in 10 secs...\n");
@@ -2720,7 +2707,6 @@ static void tlan_phy_finish_auto_neg(struct net_device *dev)
}
-#ifdef MONITOR
/*********************************************************************
*
@@ -2730,18 +2716,18 @@ static void tlan_phy_finish_auto_neg(struct net_device *dev)
* None
*
* Params:
- * dev The device structure of this device.
+ * data The device structure of this device.
*
*
* This function monitors PHY condition by reading the status
- * register via the MII bus. This can be used to give info
- * about link changes (up/down), and possible switch to alternate
- * media.
+ * register via the MII bus, controls LINK LED and notifies the
+ * kernel about link state.
*
*******************************************************************/
-void tlan_phy_monitor(struct net_device *dev)
+static void tlan_phy_monitor(unsigned long data)
{
+ struct net_device *dev = (struct net_device *) data;
struct tlan_priv *priv = netdev_priv(dev);
u16 phy;
u16 phy_status;
@@ -2753,30 +2739,25 @@ void tlan_phy_monitor(struct net_device *dev)
/* Check if link has been lost */
if (!(phy_status & MII_GS_LINK)) {
- if (priv->link) {
- priv->link = 0;
+ if (netif_carrier_ok(dev)) {
printk(KERN_DEBUG "TLAN: %s has lost link\n",
dev->name);
+ tlan_dio_write8(dev->base_addr, TLAN_LED_REG, 0);
netif_carrier_off(dev);
- tlan_set_timer(dev, (2*HZ), TLAN_TIMER_LINK_BEAT);
- return;
}
}
/* Link restablished? */
- if ((phy_status & MII_GS_LINK) && !priv->link) {
- priv->link = 1;
+ if ((phy_status & MII_GS_LINK) && !netif_carrier_ok(dev)) {
+ tlan_dio_write8(dev->base_addr, TLAN_LED_REG, TLAN_LED_LINK);
printk(KERN_DEBUG "TLAN: %s has reestablished link\n",
dev->name);
netif_carrier_on(dev);
}
-
- /* Setup a new monitor */
- tlan_set_timer(dev, (2*HZ), TLAN_TIMER_LINK_BEAT);
+ priv->media_timer.expires = jiffies + HZ;
+ add_timer(&priv->media_timer);
}
-#endif /* MONITOR */
-
/*****************************************************************************
******************************************************************************
diff --git a/drivers/net/ethernet/ti/tlan.h b/drivers/net/ethernet/ti/tlan.h
index 2eb33a2..4ced905 100644
--- a/drivers/net/ethernet/ti/tlan.h
+++ b/drivers/net/ethernet/ti/tlan.h
@@ -195,6 +195,7 @@ struct tlan_priv {
u32 timer_set_at;
u32 timer_type;
struct timer_list timer;
+ struct timer_list media_timer;
struct board *adapter;
u32 adapter_rev;
u32 aui;
@@ -206,7 +207,6 @@ struct tlan_priv {
u8 tlan_rev;
u8 tlan_full_duplex;
spinlock_t lock;
- u8 link;
struct work_struct tlan_tqueue;
u8 neg_be_verbose;
};
@@ -219,7 +219,6 @@ struct tlan_priv {
*
****************************************************************/
-#define TLAN_TIMER_LINK_BEAT 1
#define TLAN_TIMER_ACTIVITY 2
#define TLAN_TIMER_PHY_PDOWN 3
#define TLAN_TIMER_PHY_PUP 4
--
Ondrej Zary
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/