[PATCH 1/2] ARM: tegra: roth: fix unsupported pinmux properties

[Alexandre Courbot]

The pinmux subsystem complained that the nvidia,low-power-mode property
is not supported by the sdio1, sdio3 and gma drive groups. In addition
gma also does not support nvidia,drive-type. Remove these properties so
the pinmux configuration can properly be applied.

Signed-off-by: Alexandre Courbot <acourbot@xxxxxxxxxx>
---
 arch/arm/boot/dts/tegra114-roth.dts | 4 ----
 1 file changed, 4 deletions(-)

diff --git a/arch/arm/boot/dts/tegra114-roth.dts b/arch/arm/boot/dts/tegra114-roth.dts
index 0b0e8e07d965..a67885250f81 100644
--- a/arch/arm/boot/dts/tegra114-roth.dts
+++ b/arch/arm/boot/dts/tegra114-roth.dts
@@ -730,7 +730,6 @@
 				nvidia,pins = "drive_sdio1";
 				nvidia,high-speed-mode = <TEGRA_PIN_ENABLE>;
 				nvidia,schmitt = <TEGRA_PIN_DISABLE>;
-				nvidia,low-power-mode = <TEGRA_PIN_LP_DRIVE_DIV_1>;
 				nvidia,pull-down-strength = <36>;
 				nvidia,pull-up-strength = <20>;
 				nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_SLOW>;
@@ -740,7 +739,6 @@
 				nvidia,pins = "drive_sdio3";
 				nvidia,high-speed-mode = <TEGRA_PIN_ENABLE>;
 				nvidia,schmitt = <TEGRA_PIN_DISABLE>;
-				nvidia,low-power-mode = <TEGRA_PIN_LP_DRIVE_DIV_1>;
 				nvidia,pull-down-strength = <36>;
 				nvidia,pull-up-strength = <20>;
 				nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_FASTEST>;
@@ -750,12 +748,10 @@
 				nvidia,pins = "drive_gma";
 				nvidia,high-speed-mode = <TEGRA_PIN_ENABLE>;
 				nvidia,schmitt = <TEGRA_PIN_DISABLE>;
-				nvidia,low-power-mode = <TEGRA_PIN_LP_DRIVE_DIV_1>;
 				nvidia,pull-down-strength = <2>;
 				nvidia,pull-up-strength = <2>;
 				nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_FASTEST>;
 				nvidia,slew-rate-falling = <TEGRA_PIN_SLEW_RATE_FASTEST>;
-				nvidia,drive-type = <1>;
 			};
 		};
 	};
-- 
2.0.0

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/