Re: [RFC PATCH 3/9] irqchip: GIC: Convert to EOImode == 1

From: Rob Herring
Date: Wed Jun 25 2014 - 10:08:53 EST


On Wed, Jun 25, 2014 at 8:56 AM, Anup Patel <anup@xxxxxxxxxxxxxx> wrote:
> Hi Marc,
>
> On Wed, Jun 25, 2014 at 2:58 PM, Marc Zyngier <marc.zyngier@xxxxxxx> wrote:
>> So far, GICv2 has been used in with EOImode == 0. The effect of this
>> mode is to perform the priority drop and the deactivation of the
>> interrupt at the same time.
>>
>> While this works perfectly for Linux (we only have a single priority),
>> it causes issues when an interrupt is forwarded to a guest, and when
>> we want the guest to perform the EOI itself.
>>
>> For this case, the GIC architecture provides EOImode == 1, where:
>> - A write to the EOI register drops the priority of the interrupt and leaves
>> it active. Other interrupts at the same priority level can now be taken,
>> but the active interrupt cannot be taken again
>> - A write to the DIR marks the interrupt as inactive, meaning it can
>> now be taken again.
>>
>> We only enable this feature when booted in HYP mode. Also, as most device
>> trees are broken (they report the CPU interface size to be 4kB, while
>> the GICv2 CPU interface size is 8kB), output a warning if we're booted
>> in HYP mode, and disable the feature.
>>
>> Signed-off-by: Marc Zyngier <marc.zyngier@xxxxxxx>
>> ---

[...]

>> + if (resource_size(&cpu_res) >= SZ_8K)
>> + supports_deactivate = true;
>> + else
>> + pr_warn("GIC: CPU interface size is %x, DT is probably wrong\n", (int)resource_size(&cpu_res));
>
> This will not work on APM X-Gene because, for
> X-Gene first CPU page is at 0x78020000 and
> second CPU page is at 0x78030000.

Does 0x7802f000 for the cpu address not work? It should if X-Gene is
"SBSA compliant" for whatever that is worth.

Rob
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/