[PATCH 09/11] tlan: Don't disable internal PHY on cards that use it in 10 Mbps mode

[Ondrej Zary]

In tlan_reset_adapter, we disable internal PHY when an external one is used.
On cards which use internal PHY in 10 Mbps mode, we enable it later when
setting 10 Mbps mode but it does not really work (PHY fails to reset).
Leave it enabled instead.

Signed-off-by: Ondrej Zary <linux@xxxxxxxxxxxxxxxxxxxx>
---
 drivers/net/ethernet/ti/tlan.c |    8 +++-----
 1 file changed, 3 insertions(+), 5 deletions(-)

diff --git a/drivers/net/ethernet/ti/tlan.c b/drivers/net/ethernet/ti/tlan.c
index 1f878b9..bb805c2 100644
--- a/drivers/net/ethernet/ti/tlan.c
+++ b/drivers/net/ethernet/ti/tlan.c
@@ -2238,7 +2238,9 @@ tlan_reset_adapter(struct net_device *dev)
 		}
 	}
 
-	if (priv->phy_num == 0)
+	/* don't power down internal PHY if we're going to use it */
+	if (priv->phy_num == 0 ||
+	   (priv->adapter->flags & TLAN_ADAPTER_USE_INTERN_10))
 		data |= TLAN_NET_CFG_PHY_EN;
 	tlan_dio_write16(dev->base_addr, TLAN_NET_CONFIG, (u16) data);
 
@@ -2689,7 +2691,6 @@ static void tlan_phy_finish_auto_neg(struct net_device *dev)
 	struct tlan_priv	*priv = netdev_priv(dev);
 	u16		an_adv;
 	u16		an_lpa;
-	u16		data;
 	u16		mode;
 	u16		phy;
 	u16		status;
@@ -2722,9 +2723,6 @@ static void tlan_phy_finish_auto_neg(struct net_device *dev)
 	    (priv->adapter->flags & TLAN_ADAPTER_USE_INTERN_10) &&
 	    (priv->phy_num != 0)) {
 		priv->phy_num = 0;
-		data = TLAN_NET_CFG_1FRAG | TLAN_NET_CFG_1CHAN
-			| TLAN_NET_CFG_PHY_EN;
-		tlan_dio_write16(dev->base_addr, TLAN_NET_CONFIG, data);
 		tlan_set_timer(dev, (400*HZ/1000), TLAN_TIMER_PHY_PDOWN);
 		return;
 	}
-- 
Ondrej Zary

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/