Re: Lattice ECP3 FPGA with i.MX6

[Stefan Roese]

On 03.07.2014 14:37, Jean-Michel Hautbois wrote:
> I have a board, with a Freescale i.MX6 chip and a ECP3-35 FPGA on SPI.
> I tried to load the firmware using the lattice-ecp3-config driver, but
> it fails with this error :
>
> lattice-ecp3 spi32766.3: FPGA bitstream configuration driver registered
> lattice-ecp3 spi32766.3: Error: No supported FPGA detected (JEDEC_ID=808004c2)!
>
> In the driver, the id is :
>
> #define ID_ECP3_35 0xc2048080
>
> Obviously, there is a big/little endian issue... Do I need to instruct
> the device-tree in a specific way in order to get the bus in the
> correct order ? Or is this a known issue maybe ?

No. This driver was implemented and tested in a MPC5200 system. Most 
likely I missed some endian issues as you already noticed. I suggest you 
start with looking at this line:

	jedec_id = *(u32 *)&rxbuf[4];

And add some endian functions here, e.g. be32_to_cpu(). This might help 
with the detection. But other endian related issues might still be 
present in other parts of the driver as well.

HTP.

Thanks,
Stefan

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/